User manual YAMAHA MOTIFES

[. . . ] MOTIF ES Owner`s Manual English SPECIAL MESSAGE SECTION PRODUCT SAFETY MARKINGS: Yamaha electronic products may Battery Notice: This product MAY contain a small non-rechargable battery which (if applicable) is soldered in place. The average life span of this type of battery is approximately five years. When replacement becomes necessary, contact a qualified service representative to perform the replacement. have either labels similar to the graphics shown below or molded/stamped facsimiles of these graphics on the enclosure. The explanation of these graphics appears on this page. [. . . ] Both "sort" and "direct" are applied to your keyboard performance. Both "thru" and "direct" are applied to your keyboard performance. n If the Arpeggio Category (above) is set to "Ctrl, " the Voice will not sound unless "direct" is selected here. n With the "sort" and "thru" settings, the order in which notes are played back will depend on the Arpeggio sequence data. VelMode (Velocity Mode) This determines the playback velocity of the Arpeggio, or how it responds to your own playing strength. Settings: original, thru original. . . . . . . . . . . . . The Arpeggio plays back at the preset velocities included in the Arpeggio sequence data. The Arpeggio plays back according to the velocity of your playing. For example, if you play the notes strongly, the playback volume of the Arpeggio increases. [SF2] LIMIT NoteLimit Determines the lowest and highest notes in the Arpeggio's note range. Notes played in this range trigger the Arpeggio. Settings: C -2 ~ G8 n You can also create a lower and an upper trigger range for the Arpeggio, with a note range "hole" in the middle, by specifying the highest note first. For example, setting a Note Limit of "C5 - C4" lets you trigger the Arpeggio by playing notes in the two ranges of C -2 to C4 and C5 to G8; notes played between C4 and C5 have no effect on the Arpeggio. n You can also set the range directly from the keyboard, by holding down the [INFORMATION] button and pressing the desired low and high keys. VelocityLimit Determines the lowest and highest velocity in the Arpeggio's velocity range. This lets you control when the Arpeggio sounds by your playing strength. Settings: 1 ~ 127 n You can also create separate low and high trigger ranges for the Arpeggio playback, with a velocity "hole" in the middle, by specifying the maximum value first. For example, setting a Velocity Limit of 93 - 34 lets you play the Arpeggio from two separate velocity ranges: soft (1 - 34) and hard (93 - 127). Notes played at middle velocities between 35 and 92 do not play the Arpeggio. Owner's Manual 191 Voice Edit mode Normal Voice Edit Common Edit [SF3] PLAY FX UnitMultiply (Unit Multi Play) These Play Effect parameters let you control the playback of the Arpeggio in useful and interesting ways. By changing the timing and velocity of the notes, you can change the rhythmic "feel" of the Arpeggio. For example, if you set a value of 200%, the playback time will be doubled (tempo is halved). On the other hand, if you set a value of 50%, the playback time will be halved (tempo is doubled). Normal playback time is 100%. Settings: 50%, 66%, 75%, 100%, 133%, 150%, 200% Swing Delays notes on even-numbered beats (backbeats) to produce a swing feel. Settings: -120 ~ +120 QuntValue (Quantize Value) Determines to what beats the note data in the Arpeggio sequence data will be aligned, or determines to what beats in the Arpeggio sequence data the swing is applied. Settings: 32nd note 16th note triplet 16th note 8th note triplet 8th note 1/4 note triplet 1/4 note QuntStrength (Quantize Strength) The Strength value sets the "strength" by which note events are pulled toward the nearest quantize beats. A setting of 100% produces exact timing set via the QuntValue parameter above. A setting of 0% results in no quantization. Settings: 0% ~ 100% VelocityRate Determines how much the Velocity of the Arpeggio playback is offset from the original value. For example, a setting of 100% means the original values are used. Settings below 100% will reduce the velocity of the Arpeggio notes, whereas settings above 100% will increase the velocities. Settings: 0% ~ 200% n The Velocity cannot be decreased or increased beyond its normal range of 1 to 127; any values outside that range will automatically be limited to the minimum or maximum. GateTimeRate Determines how much the Gate Time (length) of the Arpeggio notes is offset from the original value. A setting of 100% means the original values are used. [. . . ] 4, Jakarta 12930, Indonesia Tel: 21-520-2577 ITALY Yamaha Musica Italia S. P. A. Combo Division Viale Italia 88, 20020 Lainate (Milano), Italy Tel: 02-935-771 CENTRAL & SOUTH AMERICA MEXICO Yamaha de Mexico S. A. De C. V. , Departamento de ventas Javier Rojo Gomez No. 1149, Col. Tel: 55-5804-0600 KOREA Yamaha Music Korea Ltd. [. . . ]