User manual YAMAHA MQ802-MQ1202-MQ1602

[. . . ] To change the setting use a "minus" screwdriver to rotate the selector dial so that the correct voltage appears next to the pointer on the panel. EN Introduction SPECIAL MESSAGE SECTION (for YDP-160) PRODUCT SAFETY MARKINGS: Yamaha electronic Battery Notice: This product MAY contain a small non- products may have either labels similar to the graphics shown below or molded/stamped facsimiles of these graphics on the enclosure. The explanation of these graphics appears on this page. Please observe all cautions indicated on this page and those indicated in the safety instruction section. rechargable battery which (if applicable) is soldered in place. The average life span of this type of battery is approximately five years. [. . . ] Try combining this voice with piano in DUAL mode. YDP-160/140 Owner's Manual 19 Selecting & Playing Voices Using the Pedals Damper (Right) Pedal The damper pedal functions in the same way as a damper pedal on an acoustic piano. When the damper pedal is pressed, notes sustain longer. Releasing the pedal immediately stops (damps) any sustained notes. The damper pedal features a half-pedal function. If the damper pedal doesn't work, make sure that the pedal cord is properly plugged into the main unit (page 37). This function allows the sustain length to vary depending on how far the pedal is pressed. The farther you press the pedal, the more the sound sustains. For example, if you press the damper pedal and all notes you are playing sound a bit murky and loud with too much sustain, you can release the pedal half way to subdue the sustain (murkiness). Organ and string voices will continue to sound for as long as the sostenuto pedal is depressed. When you press the damper pedal here, the notes you play before you release the pedal sustain longer. Sostenuto (Center) Pedal If you play a note or chord on the keyboard and press the sostenuto pedal while the note(s) are held, those notes will sustain as long as you hold the pedal (as if the damper pedal had been pressed) but all subsequently played notes will not be sustained. This makes it possible to sustain a chord, for example, while other notes are played "staccato. " When you press the sostenuto pedal here while holding the note, the note will sustain as long as you hold the pedal. Soft (Left) Pedal The soft pedal reduces the volume and slightly changes the timbre of notes played while the pedal is pressed. The soft pedal will not affect notes that are already playing when it is pressed. 18 20 YDP-160/140 Owner's Manual Selecting & Playing Voices Adding Variations to the Sound ­ Reverb This control enables you to select various digital reverb effects that add extra depth and expression to the sound to create a realistic acoustic ambience. Procedure While holding down the [PIANO/VOICE] button, press one of the C2­E2 keys to select a reverb type. C2 D2 The lowest key C2 D2 E2 Key C2 C2 D2 D2 E2 Reverb Type Room Hall1 Hall2 Stage Off Description This setting adds a continuous reverb effect to the sound, similar to the acoustic reverberation you would hear in a room. For a "bigger" reverb sound, use the HALL 1 setting. [DEMO/SONG] + [PIANO/VOICE] + B 2 key (the first black key to the left of C3): Transposes the pitch down a whole tone (two semitones). [DEMO/SONG] + [PIANO/VOICE] + F 2 key: Transposes the pitch down by six semitones. [DEMO/SONG] + [PIANO/VOICE] + C 3 key (black key to the right of C3): Transposes the pitch up by one semitone. [DEMO/SONG] + [PIANO/VOICE] + D3 key (the first white key to the right of C3): Transposes the pitch up a whole tone (two semitones). [DEMO/SONG] + [PIANO/VOICE] + F 3 key: Transposes the pitch up by six semitones. Fine-tuning the Pitch You can fine-tune the pitch of the entire instrument. This function is useful when you play the digital piano along with other instruments or CD music. Procedure To tune up (in about 0. 2Hz steps): Press and hold down the A­1, B­1 and C0 keys simultaneously, and press any key between C3 and B3. To tune down (in about 0. 2Hz steps): Press and hold down the A­1, B­1 and C 0 keys simultaneously, and press any key between C3 and B3. To restore standard pitch: Press and hold down the A­1, B­1, C0 and C 0 keys simultaneously, and press any key between C3 and B3. To tune up A-1 Hz (Hertz): This unit of measurement refers to the frequency of a sound and represents the number of times a sound wave vibrates in a second. To tune down B-1 A-1 C0 To restore standard pitch B-1 C0 A-1 C0 C3 B3 B-1 C0 Setting range: 427. 0­453. 0 Hz Standard pitch: 440. 0 Hz 21 YDP-160/140 Owner's Manual 23 Selecting & Playing Voices Using the Metronome Your digital piano features a built-in metronome (a device that keeps an accurate tempo) that is convenient for practicing. Procedure 1. Start the metronome. Press the [METRONOME] button to turn on the metronome. Determines the Time Signature While holding down the [METRONOME] button, press one of the C3­F3 keys. C3 D3 C3 D3 E3 F3 The highest key C3 key: No downbeat, C 3 key: 2/4, D3 key: 3/4, D 3 key: 4/4, E3 key: 5/4, F3 key: 6/4 Adjusting the Tempo You can adjust the metronome tempo by pressing the [+] or [­] button while the metronome is playing. The tempo of the metronome and preset song playback can be set from 32 to 280 beats per minute. [. . . ] Tel: 714-522-9011 FRANCE Yamaha Musique France BP 70-77312 Marne-la-Vallée Cedex 2, France Tel: 01-64-61-4000 HONG KONG Tom Lee Music Co. , Ltd. 11/F. , Silvercord Tower 1, 30 Canton Road, Tsimshatsui, Kowloon, Hong Kong Tel: 2737-7688 ITALY Yamaha Musica Italia S. P. A. Viale Italia 88, 20020 Lainate (Milano), Italy Tel: 02-935-771 CENTRAL & SOUTH AMERICA MEXICO Yamaha de México S. A. 09300, México, D. F. , México Tel: 55-5804-0600 INDONESIA PT. [. . . ]