User manual YAMAHA MSH-115

[. . . ] When lifting the snare drum, always use your hands to support and hold onto the drum so that it does not fall A forward, hitting the person in front of you and causing injury. When returning the drum to its normal playing position, never hold onto the drum at the positions marked ?A?Removing the Snare Drum from the Carrying Holder When removing the snare drum from the carrying holder, the frame assembly is attached to the snare drum so loosen the screws on the arm bracket and remove the frame assembly from the arms. [. . . ] ? 2 Arm Bracket ????? Arm Bracket B ????? Notch for securing slide-at-tachment on the carrying holder slide base. Tighten the clamp screw to secure the snare drum. Adjust the height and width of the carrying holder arms, and then tighten the screws to secure. Insert the arms into the arm brackets on the frame assembly. (Position the Carrying Holder instrument so that it is facing the holder ???) Once the position is Arm determined, tighten the screws on the arm brackets to secure the arms. When the C instrument is properly positioned the screws lock into the notches. ???? ??????????? ????????????? Adjust the arm support ??? Repositioning of the arm support brackets Tighten ???3?? Loosen 3 positions ?9150S?2?? * 9150S: 2 positions ?Removing the Snare Drum from the Carrying Holder When removing the snare drum from the carrying holder, the frame assembly is attached to the snare drum so loosen the screws on the arm bracket and remove the frame assembly from the arms. Also, when the placing the snare drum back on the carrying holder, make sure that the screws on the arm brackets are tightened to secure. Snare Head Angle Adjustment ??????????????????????????????????? The angle of the snare drum head can be adjusted by using the angle adjustment nut. ????????????????????? 2 ????????? Arm Bracket ????? Arm Bracket Carrying Holder ???????? B Notch for securing Arm C slide-at-tachment on the carrying holder slide base. Tighten the clamp screw to secure the snare drum. Adjust the height and width of the carrying holder arms, and then tighten the screws to secure. Insert the arms into the arm brackets on the frame assembly. (Position the instrument so that it is facing the holder (refer to diagram C). [. . . ] ) Once the position is determined, tighten the screws on the arm brackets to secure the arms. When the instrument is properly positioned the screws lock into the notches. To determine the angle, tilt the carrying holder. [. . . ]