User manual YAMAHA MT3X

[. . . ] Retain this Owner's Manual in a safe place for future reference. FOR CANADIAN CUSTOMERS To prevent electric shock, match wide blade of plug to wide slot and fully insert. This Class B digital apparatus complies with Canadian ICES-003. 13 14 Read these instructions. Install in accordance with the manufacturer's instructions. [. . . ] · If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries. · Do not throw away batteries with general house waste; dispose of them correctly in accordance with your local regulations. · The area between the remote control and this unit must be clear of large obstacles. · Do not spill water or other liquids on the remote control. · Do not drop the remote control. · Do not leave or store the remote control in the following types of conditions: ­ high humidity, such as near a bath ­ high temperature, such as near a heater or a stove ­ extremely low temperatures ­ dusty places · Do not expose the remote control sensor to strong lighting, in particular, an inverter type fluorescent lamp; otherwise, the remote control may not work properly. If necessary, position the unit away from direct lighting. 6 En PREPARATION CONNECTIONS Connecting your amplifier CAUTION · Before making any connection, switch OFF the power to the unit, the amplifier and any other component. · Connections should be made to the correct input terminals of the amplifier or another component. · If the placement of this unit causes noise to another equipment, such as a tuner, move them further away from each other. PREPARATION RCA stereo cable (supplied) Optical cable Coaxial cable Amplifier · The digital output is turned off when this unit is in PURE DIRECT mode. To connect this unit to your amplifier, choose one of the ways listed below. When the ANALOG OUT terminals of this unit are used ( ) Connect these terminals to the CD (or AUX) terminals of the amplifier by using a supplied RCA stereo cable. y This setting is retained even if you turn off this unit. For an Audio CD, playback starts from the first track, and for a Data Disc, in alphanumeric order by filename. Display information in step 2 Audio CD Starting playback Playing back discs Audio CD Data Disc Data Disc Total number of tracks Total recorded time of a disc 1 Press OPEN/CLOSE to open the disc tray, and load a disc. Label side up. Total number of files English Disc tray 9 En BASIC OPERATION Playing back USB devices USB Turning off the power Press POWER again. If you turn off the power when disc mode is selected, the next time you turn the power on, playback starts automatically of the disc on the tray. If you turn off the power when USB mode is selected, playback will start automatically of the USB device connected. Connect your USB device to the USB port on the front panel. (For details, refer to page 8. ) When USB mode is selected (USB indicator lights up), first filename is displayed in the front panel display (refer to page 12), and playback starts automatically in order by date and time of creation if playable files are in the USB device. To disconnect USB devices Press to stop playback, and then disconnect the USB device. Playing back a desired track Audio CD Select a desired track by using the numeric buttons. Example: To select track number 12 Press "1", and then press "2". Note Do not disconnect your USB device while playing back from the USB device, or when the USB indicator blinks. + Following information is displayed. Pausing playback Audio CD Data Disc USB The selected track number Press e. Playback starts in 2 seconds. Note This operation is not available for Data Disc and USB. y You can also select and playback a desired track during playback. To resume playback, press e again (or press h). Stopping playback Audio CD Data Disc USB To improve audio quality (PURE DIRECT mode) Audio CD Data Disc USB Press s. Press PURE DIRECT. This unit is set to PURE DIRECT mode. If you press h again, playback starts from the first track. · The PURE DIRECT indicator lights up. [. . . ] The product is guaranteed to be free from defects in workmanship or materials for a period of two years from the date of the original purchase. Yamaha undertakes, subject to the conditions listed below, to have the faulty product or any part(s) repaired, or replaced at Yamaha's discretion, without any charge for parts or labour. Yamaha reserves the right to replace a product with that of a similar kind and/or value and condition, where a model has been discontinued or is considered uneconomic to repair. The original invoice or sales receipt (showing date of purchase, product code and dealer's name) MUST accompany the defective product, along with a 2. [. . . ]