User manual YAMAHA MT44

[. . . ] Objects have fallen, or liquid has been spilled into the unit; or C. The unit has been exposed to rain; or D. The unit does not appear to operate normally or exhibits a marked change in performance; or E. The unit has been dropped, or the cabinet damaged. WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. 1 Read Instructions -- All the safety and operating instructions should be read before the unit is operated. 16 Servicing -- The user should not attempt to service the unit beyond those means described in the operating instructions. [. . . ] · To start recording from the end of a previous recording Press & to set this unit to stop mode. · To record over a previous recording Turn the jog dial (or press SKIP $ or > on the remote) to select a track (recording starts from the beginning of the deleted track), or press ^ (PAUSE * on the remote) during playback to pause at the point where you want to start recording. Continued on next page ! SKIP / REC 2 4 $ > PAUSE STOP TIME REC SYNC 6 PAUSE * STOP & PLAY < * & ? CD-P s MDX 13 4 Press REC (REC on the remote) to set this unit to record pause mode. The REC * indicators light up. "REC Standby" and the amount of time available for recording flash alternately in the display. If you selected a track number or paused playback (in step 3) to record over a previous recording "OverWrite OK?" appears in the display. This operation will erase the selected track number (or point) and all subsequent material. Adjust the recording level corresponding to the audio input you selected in step 2. Refer to "Adjusting Recording Levels" on this page for more details. Note When recording from a digital source that has a digital output (volume) control, set the output level (volume) to "MAX". Recording may not be possible at low output levels (when the digital volume is turned down). Adjusting Recording Levels Setting the digital volume level The volume level of digital audio sources is often similar, however, level differences may be quite obvious between different digital audio formats and even between one recording and another. To maintain a consistent volume level in MD recordings, it is possible to change the volume of the input digital signal. During recording, if no sound is detected for more than 1. 5 seconds, the recorder interprets this to be a gap between two tracks. When the source signal is detected again, a track number is automatically written. Manual : One track number is written automatically when you start recording, but none are written during recording. To mark a track number, press M-MARK at the desired position while recording. Note When using manual marking, the marks must be set at least 4 seconds apart. 4 TITLE CHAR. NUMBER DELETE SET SEARCH M-MARK MONO/ST INPUT ! SKIP / REC 1 3 $ PLAY > PAUSE STOP TIME REC SYNC < * & ? CD-P s MDX 1 Press INPUT repeatedly to select the input connected to the sound source you want to record. When recording digital signals Track numbers are written in the same positions as the original source (CD, etc. ) with either automatic or manual marking. To add additional track numbers, set M-MARK to MANUAL and press M-MARK at the desired position while recording. Notes · When recording is paused, the portion recorded up to the pause is counted as an individual track. When recording is resumed, a new track number is created. On the other hand, if one track is recorded in continuous repetition, that track is recorded as one continuous track with a single track number. · During synchronized recording, manual track marking is not possible. 2 Locate the point where you want to start recording. 3 Press REC to set this unit to record pause mode. The REC * indicators light up. [. . . ] Program Full Additional steps cannot be programmed because the maximum number of steps (30) has already been programmed. Title Full Additional characters cannot be input for the current title because the maximum number of characters for a single title (250) has already been input. UTOC WError Error occurred when writing to the UTOC. Not Audio The inserted disc is not an audio MD. [. . . ]