User manual YAMAHA MTS-810B MTS-410A MBS-810A MSS-810A

[. . . ] ? Always check to make sure that all screws are tightened firmly. The instrument may also overturn or suddenly drop, etc. ? When making adjustments to the height or angle of the stand, do not loosen the screws abruptly. The stand or drum may suddenly overturn or drop, pinching hands or fingers in the stand?s framework, resulting in injury. [. . . ] Insert the pipe of the upper stand into the pipe of the lower stand. Adjust the arms of the stand to match the space between the two pivots of the multi tom carrier. Adjust the arms to the pivot positions and insert them firmly and completely. Adjust the height of the multi toms by moving the upper stand up and down and fasten it with wing bolt (B), then fasten the screw of the position clamp with a drum key. Wing Bolt (B) 5 MTS-810B MTS-410A ????/Assembly Procedure ?????????????????????Mount the upper stand on the lower stand. Spread the legs of the stand and secure them by tightening wing bolt (A). ? When the toms are attached to the stand, the holder can be removed. * Position the feet and the catcher as shown in the illustration below. Align the frame of the multi tom holder with the catcher on the stand and insert the holder until it stops. the upper pipe, and re-tighten wing bolt (B) securely after adjustment. Furthermore, to prevent the toms from slipping down during performance, push the position clamp against the mounting base and securely tighten its screw using a drum key. Loosen wing bolt (B) to adjust the height of the drum-heads by raising or lowering ?Wing Bolt (B) 9 MBS-810A ??????/Drum Mouning Illustrations ??????????????????????????????????????????The proper setting of the stand depends on the size of the bass drum. Please refer to the following illustrations when mounting your bass drum on the stand. For all MB-4000 or 400 series drum sizes * To mount a MB-4000 or 400 series bass drum, the arm mounting position needs to be changed. Attach the four arms at the inner holes of the stand, referring to the illustration below. Fully spread the legs of the stand and secure them by tightening wing bolt (A). * Position the legs and the arm base as shown in the illustration (left). [. . . ] * To mount a MB-100 series bass drum, attach the four arms at the inner holes of the stand. Fully spread the legs of the stand and secure them by tightening wing bolt (A). * Position the legs and the arm base as shown in the illustration (left). Loosen wing bolt (B) to adjust the height of the stand. [. . . ]