User manual YAMAHA MX-1

[. . . ] Heat ­ The unit should be situated away from heat sources such as radiators, stoves, or other appliances that produce heat. supply only of the type described in the operating instructions or as marked on the unit. 8 · Explanation of Graphical Symbols The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 9 10 Power Sources ­ The unit should be connected to a power 11 Power-Cord Protection ­ Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit. 12 Cleaning ­ The unit should be cleaned only as IMPORTANT!Please record the serial number of this unit in the space below. [. . . ] One that lets the sound come through loud and clear without annoying blaring or distortion ­ and, most importantly, without affecting your sensitive hearing. Since hearing damage from loud sounds is often undetectable until it is too late, YAMAHA and the Electronic Industries Association's Consumer Electronics Group recommend you to avoid prolonged exposure from excessive volume levels. FEATURES q <MX-1>: <MX-2>: q q q q 200W + 200W (8) RMS Output Power, 0. 008% THD, 20­20, 000 Hz 150W + 150W (8) RMS Output Power, 0. 008% THD, 20­20, 000 Hz Increased Low Impedance Drive Capability 2-Pair Speaker Drive Capability REMOTE CONTROL Connector to Make the Power of This Unit Controlled by the Pre-Amplifier CX-1 or CX-2 Gold-Plated Input Terminals 3 CONNECTIONS q q Before attempting to make any connections to or from this unit, be sure to first switch OFF the power to this unit and to any other components to which connections are being made. When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left) to L, R (right) to R, "+" to "+" and "­" to "­". Also, refer to the owner's manual for each component to be connected to this unit. <MX-1> Speakers A Pre-amplifier etc. Right REMOTE CONTROL PRE OUT Left (U. S. A. model) LEVEL INPUT REMOTE CONTROL ( PRE AMP ) A OR B:2MIN. / HAUT-PARLEUR Right To AC outlet Left Speakers B <MX-2> Speakers A Pre-amplifier etc. model) LEVEL Right REMOTE CONTROL PRE OUT REMOTE CONTROL ( PRE AMP ) A OR B:2MIN. / HAUT-PARLEUR INPUT Right To AC outlet Left Speakers B 4 CONNECTING SPEAKERS Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and ­ markings are observed. If these wires are reversed, the sound will be unnatural and will lack bass. How to Connect: Red: positive (+) Black: negative (­) q q q One or two speaker systems can be connected to this unit. If you connect only one speaker system, connect it to either the SPEAKERS A or B terminals. Use speakers with the specified impedance shown on the rear of this unit. Banana Plug connections are also possible (except for Scandinavian models). Simply insert the Banana Plug connector into the corresponding terminal. *When connecting Banana Plugs to this unit's SPEAKERS terminals, be sure to tighten the terminal knobs to make contact securely before connections. Unscrew the knob. Tighten the knob and secure the wire. Caution When inserting the stripped ends of the speaker wires as shown above, make sure at least 1/16 inch (1. 6 mm) of insulation is inside the wire holders (i. e. no exposed wire is visible) and no loose conductor wire strands are protruding after connection. [. . . ] and Canada models]. . . . . . . . . . . . . . . . . . . . . . . . . . 440 VA, 340W [Australia, U. K. , Europe and General models] . . . . . . . . . . . . . 360W <MX-1> <MX-2> 8 ohms, 100W, 0. 03% THD . . . . . . . . . . . . . . . . . . . . . . . . . 10 Hz to 60 kHz 8 ohms, 75W, 0. 03% THD . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Hz to 60 kHz Maximum Power Consumption (10% THD) [General model only] <MX-1> . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1950W <MX-2> . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1600W Dimensions (W x H x D) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 486 x 116 x 438 mm (19-1/8" x 4-9/16" x 17-1/14") Weight Damping Factor 8 ohms, 1 kHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 250 or more 8 ohms, 20 Hz­20 kHz (When using the SPEAKERS A terminals) . . . . . . . . 350 or more <MX-1> . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24. 0 kg (52 lbs. 13 oz. ) <MX-2> . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19. 5 kg (42 lbs. 14 oz. ) Specifications subject to change without notice. YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE. , BUENA PARK, CALIF. 135 MILNER AVE. , SCARBOROUGH, ONTARIO M1S 3R1, CANADA ELECTRONIK EUROPA G. m. b. H. [. . . ]