User manual YAMAHA MY16-AT

[. . . ] * The company names and product names in this Owner's Manual are the trademarks or registered trademarks of their respective companies. めてください。 * この取扱説明書に掲載されている会社名および製品名は、それぞれ各社の商標または登録商標です。 * TDIF は、ティアック株式会社の商標です。 –1– PRECAUTIONS WARNING Failure to observe the following warnings may lead to fatality or serious injury from fire or electric shock. [. . . ] Compliance with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA90620 2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Failure to follow instructions could void your FCC authorization to use this product in the USA. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. [. . . ] 2/96kHz***) D-sub 25pin x2 MY16-TD* TDIF-1 * ** *** * ** *** * ** *** * ** *** * ** *** If you use the MY16-AE or MY16-TD in Double Channel mode, selecting on the console’s Word Clock Select page a slot that has the card installed enables the console to synchronize to the 88. If you use the card in Double Channel mode (FS: 88. [. . . ]