User manual YAMAHA MY8-LAKE

[. . . ] This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Failure to follow instructions could void your FCC authorization to use this product in the USA. [. . . ] NOTE • For host devices unrecognized by the MY8-AE96 (such as DIO8), you will need to change the emulation mode of the card to MY8-AT by tapping the [Operation Mode] magnifying glass icon at the bottom left of the screen and reboot the host device. Tap one of the blue boxes in the module’s input mixer block diagram. €¢ The digital clock and input configuration summary can be found at the top left of the screen. the Input Mixer screen will be displayed. You can adjust the input level, and route or disconnect input signals to any module by using the ON/ OFF buttons and fader controls. Tap any of the magnifying glass icons on the far right of the screen. The Output Configuration screen will be displayed allowing you to route any MY8-LAKE Owner’s Manual 15 available audio source to any available output destination. levels Screen The Levels screen provides access to controls for gain , delay , LimiterMax , input mixer , mutes and polarity adjustments. This section describes various example scenarios to highlight key functionality. The orange numbered blocks show which module output is routed to which of the currently selected “Destination” outputs. The currently displayed audio “Source” defaults to show the number of “Module Outputs” channels listed on the left and the visible audio “Destination” defaults to display the “Host” returns. The currently displayed view can be changed by tapping the appropriate left or right arrows beneath the “Source” and “Destination” labels. NOTE Tap an orange numbered button to disconnect that source/destination routing only (turns blue); tap a blue numbered button to patch the source to the destination. The Disconnect All button can be used to disconnect all outputs for the displayed source/destination matrix. Tap the [Home] button, then tap a module icon. If a submenu is not selected, tapping a module icon provides a shortcut to the EQ, Levels and HPF/LPF or XOVER screens for the selected module. Tap the [Levels] tab at the top left of the screen (if not already selected) then tap the red [Output MUTED] button to unmute the Mesa module output. nOTE Mesa EQ modules do not have a separate module input mute. Input Router and Input Mixer mutes and connectivity can be reviewed by tapping the associated magnifying glass icon shown below. Make any changes as required, then tap the blue arrow at the bottom right of the screen to close the Output Configuration screen. NOTE You can also close the screen by pressing <Esc>, then pressing <F1> to return to the Home screen. Check any associated mute and level settings in the MY8-LAKE host device. [. . . ] Check input and output levels on the host device and on the Lake Controller software to ensure that the signal is not clipping at any point during the signal path. Check the FAULT LED or view “Digital Clock” at top left of the I/O Config screen in the Lake Controller software to check for any digital clocking problems. Network Control or Communication Problems Is the MY8-LAKE card correctly installed and the host device switched on?Check to ensure that the STATUS LED on the card flashes. [. . . ]