User manual YAMAHA N12

[. . . ] Owner's Manual Bedienungsanleitung Mode d'emploi Manual de instrucciones EN DE FR ES Español Français Deutsch English Explanation of Graphical Symbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The above warning is located on the rear of the unit. IMPORTANT SAFETY INSTRUCTIONS 1 2 3 4 5 6 7 8 Read these instructions. Install in accordance with the manufacturer's instructions. [. . . ] Not only does the way you pan your individual channels determine where the instruments seem to appear in the stereo sound field, but it is also vital to give each instrument its own "space" so that it does not conflict with other instruments. After you finish shaping the tone of each instrument, set the stereo image for each channel and balance the overall sound. Sometimes you may want to deliberately pan sounds close together, or even right on top of each other to emphasize their relationship. A good tip is to pan low-range instruments and any parts that are very important to the song to the center; meanwhile, pan other instruments left and right as symmetrically as possible. Normally (but this is not a rule) lead vocal, solo instruments, bass, bass drum, and snare drums will be panned to the center. Mixing into stereo Now it is time to "mix. " Adjust the volume balance between the input channels and mix all channels into the stereo bus. The mixed signals will be output from the ST OUT jacks and monitored through the Control Room section. 1. Lower all channel faders all the way down. It is usually a good idea to start with all channel faders off. It is also possible to start with all faders at their nominal settings, but it is too easy to lose perspective (balance) with this approach. Start with all faders down, then bring them up one by one to fill out the mix with each instrument. In this way, you can easily create a well-balanced mix. English 2. Make sure that the [ST] switch for the input channels you plan to mix is turned on. 3. Set the STEREO fader to the 0 position, and make sure that the STEREO [ON] switch is on. 4. Raise the input channel faders one by one. Bring the fader of the most important channel up to "0" (0 dB), then add the other instruments so that you can build the mix around that part. This is a key to a well-balanced mix. 5. Adjust the STEREO fader while keeping your eyes on the MASTER LEVEL meter to avoid overloading the input signals. The output level of the stereo mix varies depending on the input channel mix balance. To create a mix with a wide dynamic range, bring up the STEREO fader as high as possible without illuminating the OVER LED of the MASTER LEVEL meter. Panning a monaural track Pan a monaural input channel signal by turning the [PAN] control. Rotating the control clockwise raises the ratio of signal sent to the R bus. Rotating the control counterclockwise raises the ratio of signal sent to the L bus. INPUT CHANNEL(MONO) INPUT A PAN INPUT B STEREO BUS L STEREO BUS R STEREO BUS L STEREO BUS R Adjusting the stereo track balance Adjust the left and right volume balance of stereo channels. The odd channel signal will be sent to the L bus, and the even channel signal to the R bus. INPUT CHANNEL(STEREO) BALANCE L R NOTE When you are using the n8/n12 as a live SR mixer, if you pan the signals or set the stereo balance hard left or hard right, the mix may not sound wellbalanced to an audience sitting close to the left or right speakers. [. . . ] Combo Division Viale Italia 88, 20020 Lainate (Milano), Italy Tel: 02-935-771 INDIA Yamaha Music India Pvt. 5F Ambience Corporate Tower Ambience Mall Complex Ambience Island, NH-8, Gurgaon-122001, Haryana, India Tel: 0124-466-5551 CENTRAL & SOUTH AMERICA MEXICO Yamaha de México S. A. 09300, México, D. F. , México Tel: 55-5804-0600 SPAIN/PORTUGAL Yamaha Música Ibérica, S. A. 17, 200, 28230 Las Rozas (Madrid), Spain Tel: 91-639-8888 INDONESIA PT. [. . . ]