User manual YAMAHA NIO500-D16/NIO500-A16/NIO500-A8D8 OPERATION MANUAL

[. . . ] This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Failure to follow instructions could void your FCC authorization to use this product in the USA. [. . . ] To select the word clock source of the device, use the NUAGE Workgroup Manager (page 19). The [SYSTEM indicator] indicates the system status of the device on the Dante network. 6 [Power switch] Turns the power on (I) and off (P). The lamp lights when the power is on, and is unlit when the power is off. lamp Status Description The device is working properly. NOTICE Rapidly turning the unit on and off in succession can cause it to malfunction. After turning the unit off, wait for at least 6 seconds before turning it on again. left (green) Lit Left (green) Flashes (every The firmware updating is in second) progress. Right (red) Right (red) Lit The memory on the device does not work properly. Flashes (every The CPU on the device does not second) work properly. The [SYNC indicator] indicates the synchronization status of the device on the Dante network. Lamp Status Description The device is working as the slave on the Dante network. Left (green) Lit Left (green) Flashes (every The device is working as the master second) on the Dante network. right (orange) Right (orange) Lit Synchronization with the Dante network is in progress. Flashes (every The device is not synchronized with second) the Dante network. $ 14 NUAGE I/O (16D) / NUAGE I/O (16A) / NUAGE I/O (8A8D) Operation Manual Description of the Device 1 [AC IN] 6 [SECONDARY] (RJ-45 connector) For connection to the power cable. 2 [Fan] The electric fan for expelling heat and cooling the unit. 3 [UNIT ID rotary switch] The same as [PRIMARY]. However, the connection configuration varies depending on the settings of [Dip switch] (page 15). For details on how to connect the devices, refer to “Setup” (page 10). 7 [SYSTEM LINK OUT] (BNC connector) Sets the device ID on the Dante network. When connecting multiple devices, set the ID on each device to a different number. [. . . ] Also add information on how to contact you by electronic and paper mail. If the program is interactive, make it output a short notice like this when it starts in an interactive mode: Gnomovision version 69, Copyright © year name of author Gnomovision comes with ABSOLUTELY NO WARRANTY; for details type `show w'. This is free software, and you are welcome to redistribute it under certain conditions; type `show c' for details. The hypothetical commands `show w' and `show c' should show the appropriate parts of the General Public License. [. . . ]