User manual YAMAHA NS-1000MM

[. . . ] Contact qualified YAMAHA service personnel when any service is needed. The cabinet should never be opened for any reasons. CAUTIONS Read this before using the speakers. To assure the finest performance, please read this manual carefully. [. . . ] Otherwise the speakers may be damaged. REMOVING THE FRONT COVER The front cover is fastened to the enclosure at four points and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four holes on the inner surface of the cover with the four corresponding pegs on the speaker and push gently. Note When the cover is removed, be sure not to touch the speaker units with your hands or to exert excessive force with tools. SETTING UP THE SPEAKERS s To mount the speakers on a wall by using the provided mounting brackets WARNING Each speaker weighs 3. 0 kg (6 lbs. Do not mount them on thin plywood or a wall with soft surface material. If mounted, the screws may come out of the flimsy surface and the speakers may fall. This damages the speakers or causes personal injury. Do not install the speakers to a wall with nails, adhesives, or any other unstable hardware. Longterm use and vibrations may cause them to fall. To avoid accidents resulting from tripping over loose speaker cords, fix them to the wall. 1 Attach the bracket to the rear of the speaker by using the provided screws. 2 Remove the provided pads from the backing sheet and put them at the lower corners of the speakers. You can also use the screw holes on the rear and the bottom of the speaker for mounting the speakers on the wall or the ceiling (if you will not use the provided mounting brackets). Rear Bottom 64 mm 60 mm 60 mm 3 Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting bracket on the protruding screws. * Make sure that the screws are securely caught by the narrow parts of the holes. Tapping screw (Available at the hardware store) Diam. 20 mm 2 mm A screw with a diameter of 4 mm and a pitch of 0. 7 mm can be used. (Depth of hole : 10mm) Wall/ wall support CONNECTION TO YOUR AMPLIFIER BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE AMPLIFIER IS SWITCHED OFF. s Connections · Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of your amplifier with the provided speaker cables. · Connect the (+) terminals on both the amplifier and the speakers using one side of the speaker cable. [. . . ] Should this happen, move the speakers away from the TV set. Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 oz. ) x 2 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]