User manual YAMAHA NS-C444

[. . . ] Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, do not expose the speaker to rain or water. · To prevent the enclosure from warping or discoloring, do not place the speaker where it will be exposed to direct sunlight or excessive humidity. [. . . ] · Secure placement or installation is the owner's responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of speaker. PLACING THE SPEAKER Place the speaker on TV whose top is flat or on the floor under the TV or inside the TV rack so that it is stabilized. When placing the speaker on top of the TV, to prevent the speaker from falling down, put the provided fasteners at four points on the bottom of the speaker and the top of the TV. Fastener Peel off the seal Screen Note · Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. If placed, the speaker may drop out causing an injury to you. · Do not place the speaker on top of the TV with an inclination. · Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength. · Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop. · This speaker features a magnetically shielded design, but there is still a chance that placing it too close to a TV set might impair picture color. Should this happen, move the speaker away from the TV set. English 1 CONNECTIONS TO YOUR AMPLIFIER Before making connections, make sure that the amplifier is switched off. Note Do not let the bare speaker wires touch each other to avoid damaging the speaker or the amplifier, or both of them. [Using a Banana Plug] Banana Plug Loosen Tighten Black (­) Red (+) ! Speaker 1 Remove the speaker terminal cover by gently pulling it toward you. 3 Simply insert the banana plug into the terminal. CENTER + REMOVING THE FRONT COVER The front cover is fastened to the enclosure at four points and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four pegs on the inside surface of the cover with the four corresponding holes on the speaker and push gently. Amprifier or Receiver CONNECTIONS · Connect the screw-type input terminals at the rear of the speaker to the speaker output terminals of the amplifier (or receiver) with the speaker cable. · Connect the (+) terminals on the amplifier (or receiver) and the speaker using one side of the cable. [. . . ] · Care should be taken not to exceed the input power values noted above. English 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 cm × 2 2. 5 cm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55 Hz 35 kHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 W . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]