User manual YAMAHA NS-E60

[. . . ] NS-E60 Thank you for selecting this Yamaha NS-E60 speaker system. This model is designed mainly to be used as an effect speaker system. Natural Sound Bass-Reflex Type Effect Speaker System CONNECTION TO YOUR AMPLIFIER BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE AMPLIFIER IS SWITCHED OFF. Remove your finger from the tab to allow it to lock snugly on the cable's wire end. [. . . ] Never allow your amplifier to be driven into "clipping". Though this speaker is a magnetic shielding type, there may be an influence on TV picture according to the type of TV or the placement of the speaker. In such a case, place the speaker apart from the TV so that there is no influence on TV picture. Secure placing is the owner's responsibility. YAMAHA shall not be liable to any accident caused by an improper placing of the speaker. s CONNECTIONS Connect the push-type input terminals at the rear of the speakers to the speaker output terminals of your amplifier with the provided speaker cables. One side of the speaker cable is marked by a white line. Connect the (+) terminals on both the amplifier and the speakers using this white-marked side. Connect the (­) terminals on both components using the unmarked side of the cable. Connect the left speaker to the left (marked L) terminals of your amplifier, and the right speaker to the right (marked R) terminals, making sure not to reverse the polarity (+, ­). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass. Procedures: Press the tab on the terminal down, as shown in the figure. Insert the bare wire end properly into the terminal hole. 5 mm (1/4") insulation from the speaker cable. Press tab Right speaker Left speaker White line R White line L Speaker output terminals of the amplifier Note Do not let the bare wires touch each other as this could damage the speaker and/or the amplifier. SETTING UP THE SPEAKERS Set up the speakers on a shelf or rack, or hang them on the wall. s Attaching the speakers to a wall The speakers may be attached to a wall by using the hooks provided on the speakers' back panels. [. . . ] To hang in side long configuration Hang the speakers so that each of them faces inside as figured below. The speaker hooks are arranged so that the speakers can be mounted in any of the three configurations shown by the following figures. Upright configuration Type. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Full-Range Bass-Reflex type Speaker Unit. . . . . . . . 10 cm paper cone woofer (JA1074) Input Terminal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Push-type Nominal Impedance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 ohms Frequency Response . . . . . . . . . . . 70 Hz ­ 20 kHz (­10 dB) Nominal Input Power. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25W Music Input Power. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50W Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90 dB/w/m Dimensions (WxHxD) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 180 mm x 233 mm x 112 mm (7-1/16" x 9-5/16" x 3-7/16") Weight. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 4 kg (3 lbs. 1 oz. ) Accessories. . . . . . . . . . . . . . . . . . . 2 speaker cables (10m each) * Specifications subject to change without notice due to product improvements. 80 mm Wall/ wall support [. . . ]