User manual YAMAHA NS-E80

[. . . ] NS-E80 Thank you for selecting this Yamaha NS-E80 speaker system. This model is designed mainly to be used as an effect speaker system. Natural Sound Bass-Reflex Type Effect Speaker System CONNECTION TO YOUR AMPLIFIER BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE AMPLIFIER IS SWITCHED OFF. 3 Remove your finger from the tab to allow it to lock snugly on the cable's wire end. [. . . ] Also, placing the speakers near a TV set may impair picture color. If this happens, move the TV set away from the speakers. · Secure installing is the owner's responsibility. YAMAHA shall not be liable to any accident caused by a failure in installing at a proper position and by proper installation procedure. CONNECTIONS · Connect the push-type input terminals at the rear of the speakers to the speaker output terminals of your amplifier with the supplied speaker cables. · One side of the speaker cable is marked by a white line. Connect the (+) terminals on both the amplifier and the speakers using this white-marked side. Connect the (­) terminals on both components using the unmarked side of the cable. · Connect the left speaker to the left (marked L) terminals of your amplifier, and the right speaker to the right (marked R) terminals, making sure not to reverse the polarity (+, ­). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass. Procedures: 1 Press the tab on the terminal down, as shown in the figure. 2 Insert the bare wire end properly into the terminal. Press tab Right speaker White line Left speaker Speaker output terminals of the amplifier White line White line SETTING UP THE SPEAKERS Attaching the speakers to a wall The speakers may be attached to a wall by using the hooks provided on the speakers' back panels. Fasten wood screws into a firm wall or wall support as shown in the diagram, and hang the speaker hooks on the protruding screws. Upright configuration SPECIFICATIONS Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-Way Bass-Reflex type Speaker Unit . . . . . . . . 10 cm paper cone woofer (JA1064) 3 cm paper cone tweeter (JA05P6) Crossover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 kHz Input Terminal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Push-type Nominal Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 ohms Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . 90 Hz ­ 20 kHz Nominal Input Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50W Music Input Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100W Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 91 dB/W m Dimensions (WxHxD) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 mm x 270 mm x 73. 5 mm (8-11/16"x10-5/8"x2-7/8") Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 6 kg (3 lbs. [. . . ] NOTE: The speakers can be hung on a wall in one of two different configurations: vertically or horizontally. The speaker hooks have been arranged so that the speakers may be mounted in either of the two configurations shown by the following figures. Ex. ) When setting the speaker upright Setting the speakers on a shelf or rack As shown in the figure, the speakers may be stood in an upright or side-long configuration on either shelves or racks, by attaching one of the supplied stands to the back of each speaker. VP15950-0 BWWR, W Printed in Japan [. . . ]