User manual YAMAHA NS-P320

[. . . ] UB NS-P320 (Including SW-P201 subwoofer system) HOME CINEMA 5. 1CH SPEAKER PACKAGE OWNER'S MANUAL I · Explanation of Graphical Symbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. IMPORTANT Please record the serial number of this system in the space below. Model: Serial No. : The serial number is located on the rear of the main unit. [. . . ] It also may be necessary to break up the parallel surfaces by placing bookshelves etc. along the walls. ( : Subwoofer, : Main speaker) E-3 Placing the center speaker Place the speaker on TV whose top is flat or on the floor under the TV or inside the TV rack so that it is stabilized. When placing the speaker on top of the TV, to prevent the speaker from falling down, put the provided fasteners at four points on the bottom of the speaker and the top of the TV. Screen Fastener Peel off the seal Notes Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. If placed, the speaker may drop out causing an injury to you. Do not place the speaker on top of the TV with an inclination. Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength. Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop. If you want to mount a speaker on a commercially available speaker stand (for the main/rear speakers) The screw holes (at an interval of 60 mm) on the bottom and the rear of the speaker can be used to mount the speaker on a speaker stand. * Those screw holes can be used with M4 screws only. 60 mm 60 mm 60 mm 60 mm Rear speaker (bottom) Main speaker (bottom) Main speaker (rear) Rear speaker (rear) E-4 Mounting the rear speakers 1 Mount the rear speakers on a shelf, rack or directly on the floor, or hang them on the wall. 3. 5 to 4 mm To mount the rear speakers on a wall by using the holes on the speakers' back panels Note It is recommended that you connect the speaker cables to the speaker's terminals before attaching the bracket to the speaker. Min. 20 mm 6 mm Tapping screw (Available at the hardware store) 1 2 3 Put the provided pads at the four corners on the rear of the rear speakers to prevent the rear speakers from moving by vibrations. Fasten screws into a firm wall or wall support as shown in the figure. Hang the holes on the protruding screws. * Make sure that the screws are securely caught by the narrow parts of the holes. * You can use the lower holes on the rear of the rear speakers. 3 Wall/ wall support 60 mm WARNING Each speaker weighs 1. 1 kg (2 lbs. Do not mount them on thin plywood or a wall with soft surface material. If mounted, the screws may come out of the flimsy surface and the speakers may fall. This damages the speakers or causes personal injury. Do not install the speakers to a wall with nails, adhesives, or any other unstable hardware. Longterm use and vibrations may cause them to fall. To avoid accidents resulting from tripping over loose speaker cables, fix them to the wall. [. . . ] 2-way bass-reflex speaker system Magnetic shielding type Driver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 cm (2-3/4") cone woofer x 3 1. 5 cm (5/8") tweeter Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 95 Hz to 20 kHz Nominal Input Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]