User manual YAMAHA NS-P326

[. . . ] UB NS-P326 (NS-P326: NS-M104 + NS-E114 + NS-C104 + SW-P201) HOME CINEMA 6. 1CH SPEAKER PACKAGE OWNER'S MANUAL I · Explanation of Graphical Symbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. IMPORTANT Please record the serial number of this system in the space below. Model: Serial No. : The serial number is located on the rear of the main unit. [. . . ] Do not place the speaker on top of the TV with an inclination. Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength. Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop. If you want to mount a speaker on a commercially available speaker stand (for the main/rear/rear center speakers) The screw holes (at an interval of 60 mm) on the bottom and the rear of the speaker can be used to mount the speaker on a speaker stand. * Those screw holes can be used with M4 screws only. 60 mm 60 mm 60 mm 60 mm Rear/rear center speaker (bottom) Main speaker (bottom) Main speaker (rear) Rear/rear center speaker (rear) E-4 English Mounting the rear and rear center speakers 1 Mount the rear and rear center speakers on a shelf, rack or directly on the floor, or hang them on the wall. 3. 5 to 4 mm To mount the rear and rear center speakers on a wall by using the holes on the speakers' back panels 1 2 3 Put the provided pads at the four corners on the rear of the rear and rear center speakers to prevent the rear and rear center speakers from moving by vibrations. Fasten screws into a firm wall or wall support as shown in the figure. Hang the holes on the protruding screws. * Make sure that the screws are securely caught by the narrow parts of the holes. * You can use the lower holes on the rear of the rear speakers. Min. 20 mm 6 mm Tapping screw (Available at the hardware store) Wall/ wall support 3 WARNING Each speaker weighs 1. 1 kg (2 lbs. Do not mount them on thin plywood or a wall with soft surface material. If mounted, the screws may come out of the flimsy surface and the speakers may fall. This damages the speakers or causes personal injury. Do not install the speakers to a wall with nails, adhesives, or any other unstable hardware. Longterm use and vibrations may cause them to fall. To avoid accidents resulting from tripping over loose speaker cables, fix them to the wall. Select a proper position on the wall to mount the speaker so that no one will injure his/her head or face. 60 mm E-5 CONNECTIONS Caution: Plug in the subwoofer and other audio/video components after all connections are completed. An example of basic connections Main speakers Right Left Rear center speaker Center speaker R MAIN SPEAKERS REAR CENTER L CENTER + + + A ­ ­ ­ ­ ­ B + R L R REAR (SURROUND) L + SUB WOOFER OUTPUT Amplifier Subwoofer POWER ON OFF VOLUME STANDBY-RED ON-GREEN AUTO STANDBY HIGH LOW OFF 0 I0 INPUT2 /MONO INPUT1 FROM AMPLIFIER INPUT2 OUTPUT TO SPEAKERS /MONO Right Rear speakers Left E-6 To AC outlet English Basically, connect the subwoofer to the line output (pin jack) terminal(s) of the amplifier. If your amplifier does not have any line output terminal, connect the subwoofer to the speaker output terminals of the amplifier. (Refer to page 9 for details. ) * To connect with a YAMAHA DSP amplifier (or AV receiver), connect the SUBWOOFER (or LOW PASS etc. ) terminal on the rear of the DSP amplifier (or AV receiver) to the L/MONO INPUT2 terminal of the subwoofer. [. . . ] 7 cm (3") cone woofer x 3 1. 5 cm (5/8") tweeter Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 95 Hz to 20 kHz Nominal Input Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70W Maximum Input Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]