User manual YAMAHA NS-P430-436

[. . . ] UB NS-P430/ NS-P436 (NS-P430/NS-P436: NX-430P + NX-C430 + YST-SW015) HOME CINEMA 5. 1CH SPEAKER PACKAGE/ HOME CINEMA 6. 1CH SPEAKER PACKAGE OWNER'S MANUAL IMPORTANT SAFETY INSTRUCTIONS 1 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] Do not place the speaker on top of a TV if the top is inclined. Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength. Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to fall. Fastener Peel off the seal E-4 English Mounting the main/rear/center speakers (and rear center speaker for NS-P436) on the wall 1 Tapping screw (Available at the hardware store) Diam. 3. 5 to 4 mm You can mount the main, rear and/or center speakers (and/ or rear center speaker for NS-P436) on a wall. To mount the speakers on a wall, use the holes of the brackets attached on the speakers' back panels. Main/rear/rear center (for NS-P436) Min. 20 mm 4 mm Holes Wall/ wall support 2 Main/rear/rear center (for NS-P436) Center 26 mm 1 Fasten two screws into a firm wall or wall support at the interval shown below. Main/rear/rear center (for NS-P436) . . . . . . . . . . 26 mm (1") Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 222. 8 mm (8-3/4") 2 Hang the speaker by mounting the holes on the protruding screws. * Make sure that the screws are securely affixed by the narrow parts of the holes. Center 222. 8 mm WARNING Each speaker weighs as follows. Main/rear/rear center (for NS-P436) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 oz. ) Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 oz. ) Do not mount them on thin plywood or a wall composed of a soft surface material. If mounted, the screws may pull out of the flimsy surface and the speakers may fall. This may damage the speakers or cause personal injury. Do not affix the speakers to a wall using nails, adhesives, or any other unstable hardware. Longterm use and vibrations may cause the speakers to fall. To avoid accidents resulting from tripping over loose speaker cables, fix the cables to the wall. Select an appropriate position on the wall to mount the speaker so that no one will injure his/her head or face. E-5 Mounting the main/rear speakers (and rear center speaker for NS-P436) by using commercially available speaker stands or brackets You can also use the screw holes on the bottom of the speaker for installing the speakers on commericially available speaker stands (if you do not use the attached mounting brackets. ) Using the Yamaha Speaker Stand SPS-10MM (option) By using the Yamaha Speaker Stand SPS-10MM, speakers can be placed on the floor. (Two stands make a set. ) A screw with a diameter of 4 mm can be used. (Hole depth : 10 mm) 60 mm SPS-10MM * The SPS-10MM is not available in some areas. Removing the front cover Main/rear/rear center (for NS-P436) The front cover is fastened to the enclosure at four points and can be removed if desired. [. . . ] and Europe models . . . . . . . . . . . . . . . . . . . . . . . . AC 230V, 50 Hz Australia model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 240V, 50 Hz China, Korean and General models . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 110-120/220-240V, 50/60 Hz Power Consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]