User manual YAMAHA NS-P620

[. . . ] UA NS-P620 (NS-P620: NS-10MMT + NS-C10MM + YST-SW105) HOME CINEMA 5. 1CH SPEAKER PACKAGE OWNER'S MANUAL I · Explanation of Graphical Symbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. IMPORTANT Please record the serial number of this system in the space below. Model: Serial No. : The serial number is located on the rear of the main unit. [. . . ] It also may be necessary to break up the parallel surfaces by placing bookshelves etc. Use the nonskid pads Put the provided nonskid pads at the four corners on the bottom of the subwoofer to prevent the subwoofer from moving by vibrations etc. ( : Subwoofer, : Main speaker) E-3 Mounting the rear speakers 1 Mounting bracket Mount the rear speakers on a shelf, rack or directly on the floor, or hang them on the wall. To mount the rear speakers on a wall by using the provided mounting brackets 1 Screw Attach the bracket to the rear of the speaker by using the provided screws. Remove the provided pads from the backing sheet and put them at the lower corners of the speakers. Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting bracket on the protruding screws. * Make sure that the screws are securely caught by the narrow parts of the holes. 2 Pad 2 Tapping screw (3. 5­4 mm) (Available at the hardware store) Min. 20 mm 3 mm 40 mm Wall/ wall support WARNING Each speaker weighs 1. 5 kg (3 lbs. Do not mount them on thin plywood or a wall with soft surface material. If mounted, the screws may come out of the flimsy surface and the speakers may fall. This damages the speakers or causes personal injury. Do not install the speakers to a wall with nails, adhesives, or any other unstable hardware. Longterm use and vibrations may cause them to fall. To avoid accidents resulting from tripping over loose speaker cables, fix them to the wall. Select a proper position on the wall to mount the speaker so that no one will injure his/her head or face. You can also use the screw holes on the bottom of the speaker for installing the speakers on commericially available speaker stands (if you do not use the provided mounting brackets. ) A screw with a diameter of 4 mm can be used. (Hole depth : 10 mm) E-4 English Placing the center speaker Place the speaker on TV whose top is flat or on the floor under the TV or inside the TV rack so that it is stabilized. When placing the speaker on top of the TV, to prevent the speaker from falling down, put the provided fasteners at four points on the bottom of the speaker and the top of the TV. Screen Fastener Peel off the seal Notes Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. If placed, the speaker may drop out causing an injury to you. Do not place the speaker on top of the TV with an inclination. Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength. Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop. Removing the front cover The front cover is fastened to the enclosure at four points and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. [. . . ] AC 230V, 50 Hz Australia model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 240V, 50 Hz China and General models . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 110/120/220/240V, 50/60 Hz Power Consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80W (In the standby mode: 0. 8W) Dimensions (W x H x D) . . . . . . . . . . . . . . . . . . . . [. . . ]