User manual YAMAHA NSP610

[. . . ] UCA NS-P6 0 1 HOME CINEMA 5. 1CH SPEAKER PACKAGE 5. 1 SYSTEM D'ENCEINTES HOME CINEMA OWNER'S MANUAL MODE D'EMPLOI I · Explanation of Graphical Symbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. IMPORTANT Please record the serial number of this system in the space below. Model: Serial No. : The serial number is located on the rear of the main unit. [. . . ] This is because "standing waves" have been developed between two parallel walls and they cancel the bass sounds. In such a case, face the subwoofer obliquely to the wall. It also may be necessary to break up the parallel surfaces by placing bookshelves etc. Use the rubber pads Put the provided rubber pads at the four corners on the bottom of the subwoofer to prevent the subwoofer moving due to vibrations etc. ( : Subwoofer, : Main speaker) E-3 Mounting the rear speakers 1 Mount the rear speakers on a shelf, rack or directly on the floor, or hang them on the wall. To mount the rear speakers on a wall by using the provided mounting brackets Bracket Screw 1 Attach the bracket to the rear of the speaker by using the provided screws. Remove the provided pads from the backing sheet and put them at the lower corners of the speakers. Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting bracket on the protruding screws. * Make sure that the screws are securely caught by the narrow parts of the holes. 2 Pads 2 Tapping screw (4­5 mm) (Available at the hardware store) Min. 20 mm 2 mm 40 mm WARNING Each speaker weighs 1. 5 kg (3 lbs. Do not mount them on thin plywood or a wall with soft surface material. If mounted, the screws may come out of the flimsy surface and the speakers may fall. This damages the speakers or causes personal injury. Do not install the speakers to a wall with nails, adhesives, or any other unstable hardware. Longterm use and vibrations may cause them to fall. To avoid accidents resulting from tripping over loose speaker cords, fix them to the wall. Wall/ wall support You can also use the screw holes on the bottom of the speaker for installing the speakers on commericially available speaker stands (if you do not use the provided mounting brackets. ) 60 mm A screw with a diameter of 4 mm can be used. (Hole depth : 8 mm) E-4 English Mounting the center speaker Place the center speaker on top of the TV, on the floor under the TV or inside the TV rack so that it is stable. To mount the center speaker on top of the TV When placing the speaker on top of the TV, put the provided fasteners at two points on both the bottom of the speaker and on top of the TV to prevent the speaker from falling. Speaker on top of the TV TV set 1 Speaker inside the TV rack Fastener 2 Notes Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. If placed, the speaker may fall and might cause personal injury. Though this speaker is a magnetically shielded type, there may be some influence on a TV picture depending on the type of TV or the placement of the speaker. In such a case, place the speaker apart from TV so that there is no influence on TV picture. Removing the front cover The front cover is fastened to the enclosure at four points and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four holes on the inner surface of the cover with the four corresponding pegs on the speaker and push gently. Note When the cover is removed, be sure not to touch the speaker units with your hands or to exert excessive force with tools. E-5 CONNECTIONS General information for connections Caution: Plug in the subwoofer and other audio/video components after all connections are completed. Connect the main, center and rear speakers to the speaker output terminals of your amplifier with the provided speaker cords. * The provided speaker cords have labels marked FRONT L, FRONT R, CENTER, REAR L or REAR R. [. . . ] 70W/5 High-Cut Filter . . . . . . . . . . . . . . . . . . . . . . 50 Hz ­ 150 Hz (­24 dB/oct. ) Frequency Response . . . . . . . . . . . . . . . . . 30 Hz ­ 200 Hz (­10 dB) Power Supply U. S. A. and Europe models . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]