User manual YAMAHA NX-E200

[. . . ] · Install the speakers in a cool, dry, clean place ­ away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, do not expose the speakers to rain or water. · To prevent the enclosure from warping or discoloring, do not place the speakers where they will be exposed to direct sunlight or excessive humidity. [. . . ] · Do not attempt to clean the speakers with chemical solvents as this might damage the finish. · Do not attempt to modify or fix the speakers. Contact qualified YAMAHA service personnel when any service is needed. The cabinet should never be opened for any reasons. · Secure placement or installation is the owner's responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of speakers. CONNECTION TO YOUR RX-E200 RECEIVER BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE RX-E200 RECEIVER IS SWITCHED OFF. · When this unit is connected to the RX-E200 receiver, refer also to the owner's manual supplied with the receiver. I CONNECTIONS · Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of the receiver with the provided speaker cables. · One side of the speaker cable is red and the other side is black. Connect the (+) terminals on the receiver and speakers using the red side. Connect the (­) terminals on both components using the black side of the cable. · Connect one speaker to the left (marked L) terminals of the receiver, and the other to the right (marked R) terminals. Make sure not to reverse polarity (+, ­). If a speaker is connected with reverse polarity, the sound will be unnatural and lack bass. Loosen Black (­) Tighten Red (+) Red line Speaker (R) Red line Speaker (L) Black line Speaker output terminals of the receiver RX-E200 2 How to connect: 1 Loosen the knob. [Remove the insulation coating at the extremity of each speaker cable by twisting the coating off. ] Good No Good REMOVING THE FRONT COVER The front cover is fastened to the enclosure at four point and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four pegs on the inner surface of the cover with the four corresponding holes on the speaker and push gently. 3 Tighten the knob and secure the cable. Test the firmness of the connection by pulling lightly on the cable at the terminal. [. . . ] 3 kHz Dimensions (W x H x D) . . . . . . . . . . . . . . . . . 186 x 300 x 222 mm (7-5/16" x 11-13/16" x 8-3/4") Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 oz. ) x 2 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Speaker cable (4 m) x 2 * Please note that all specifications are subject to change without notice. [. . . ]