User manual YAMAHA NX-E300

[. . . ] A vessel with water in it If the vessel falls by vibrations and water spills, it may cause damage to the speakers, and/or you may get an electrical shock. · Do not place the speakers where foreign objects such as water drips might fall. It might cause a fire, damage to the speakers, and/or personal injury. · Do not place the speakers where they are liable to be knocked over or struck by falling objects. [. . . ] YAMAHA shall not be liable for any accident caused by improper placement or installation of speakers. ACCESSORIES Check that the following item is included. Speaker cable (4m) x 2 PLACING THE SPEAKERS · Place the speakers on a sturdy, vibration-free surface. You may not be able to obtain good bass quality when the speakers are placed directly on the floor. · Better stereo images will be obtained when the speakers are slightly angled in towards the listening position. Note These speakers feature a magnetically shielded design, but there is still a chance that placing them too close to a TV set might impair picture color. Should this happen, move the speakers away from the TV set. CONNECTION TO YOUR CRX-E300 CD RECEIVER BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE CRX-E300 CD RECEIVER IS SWITCHED OFF. · When this unit is connected to the CRX-E300 CD receiver, refer also to the owner's manual supplied with the receiver. I CONNECTIONS · Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of the receiver with the provided speaker cables. · One side of the speaker cable is red and the other side is black. Connect the (+) terminals on the receiver and speakers using the red side. Connect the (­) terminals on both components using the black side of the cable. · Connect one speaker to the left (marked L) terminals of the receiver, and the other to the right (marked R) terminals. Make sure not to reverse polarity (+, ­). If a speaker is connected with reverse polarity, the sound will be unnatural and lack bass. 2 When using a banana plug Loosen Tighten Black (­) Red (+) 3 Banana plug 1 2 Red line 1 Remove the cover by pulling it toward you. 3 Simply insert the banana plug into the terminal. REMOVING THE FRONT COVER Speaker (R) Speaker (L) Red line The front cover is fastened to the enclosure at four point and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four pegs on the inner surface of the cover with the four corresponding holes on the speaker and push gently. Black line Speaker output terminals of the receiver CRX-E300 How to connect: 1 Loosen the knob. 2 Remove the insulation coating at the extremity of each speaker cable by twisting the coating off. 4 Tighten the knob and secure the cable. Test the firmness of the connection by pulling lightly on the cable at the terminal. [. . . ] 8 oz. ) x 2 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Speaker cable (4 m) x 2 * Specifications are subject to change without notice due to product improvements. * Care should be taken not to exceed the input power values noted above. 3 YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE. , BUENA PARK, CALIF. 135 MILNER AVE. , SCARBOROUGH, ONTARIO M1S 3R1, CANADA ELECTRONIK EUROPA G. m. b. H. [. . . ]