User manual YAMAHA OUTBOARD MOTOR 15DM

[. . . ] Sor is of advantage when the mounting location of the regulator is not suited for measurement of temperature (see chapter 4). A telephone commander) can be connected by customers (see chapter 6. The remote control switch must be equipped with a potential-free contact which is suited for 5 V DC. OUTBOARD MOTOR 15DM is a room temperature regulator with a digital time switch (weekly programme; three heating and one reduction starting times per day) for controlling the gas heating units with continuous control listed below. [. . . ] Turn the control knob (n) to The display (e) shows: Select day +/- When no more alterations are necessary close the lid. 4 Control knob set to "Heating" Setting the heating programme The time switch makes it possible to automatically switch on the heating system up to three times a day at a pre-determined time and to automatically switch it off three times a day a pre-determined time. Those times can be determined individually for each day. It is also possible to set the same times for each day. To make programming more effective it is useful to fill in the heating times into the table provided (see chapter 10). The heating programme which is used for most days of the week (also applicable if the times deviate slightly) should be filled in for all days in the first step. All days (or the present day) is displayed in the upper line. In the setting All days both "heating operation" and "economic operation" will start at the respective times each day. Thursday) was selected, the set programme for this day always starts at the pre-set time on this day, i. Each Thursday both "heating operation" and "economic operation" will start at the set times. One single day can be set by depressing the buttons "­" (o) or "+" (p). Office which is not busy on Sundays), please enter the required starting time for economic operation (if necessary, the day before) and cancel all further starting times up to the time you wish normal heating operation to commence. If on one day of the week continuous heating operation is required, please enter the required starting time for heating operation (if necessary, the day before) and cancel all further starting times up to the time you wish economic operation to commence. If you wish to carry out extensive alterations to the programme, it might be better to start off with the programme pre-set by the factory. Proceed as described above to delete all individually set starting times, until the display shows Select day +/-. briefly depress the cancel button C (r). After this, the programme pre-set by the factory reappears (for all days: 1st starting time for heating operation 06:00 hrs; 1st starting time for economic operation 22:00 hrs, further starting times --:--). When no more alterations are necessary close the lid. The number of days absent is set by depressing the buttons "­" (o) or "+" (p). Briefly depressing the button alters the number of days absent by 1 day, when the button is depressed for a longer period the displayed days run faster. Note: The present day must be entered as a day absent, i. The day of return should only be entered if no heating operation is required for that day! [. . . ] 9 Reprogramming If you would like to carry out extensive alterations to the programme it might be better to set the regulator back to the programme preset by the factory and to re-enter all starting times. In this case please proceed as stated in the operating instructions of the heating unit or contact your local expert for heating systems. Turn the control knob (n) to the position until the display (e) shows Select day +/­ then briefly depress the cancel button C (r). If all settings, even the time and the day (and the display language) are to be deleted together with the starting times, the cancel button C (r) must be depressed for longer than 10 seconds. [. . . ]