User manual YAMAHA PC2602

[. . . ] Doing so may result in damage or deterioration to the product. · Do not step on or place heavy objects on the product. · Do not use or keep the product in places with extremely high temperature (places in direct sunlight, close to a heater, in a closed car, etc. ) or damp (bathroom, outside on a rainy day, etc. ). [. . . ] · To clean the product, please wipe with a soft cloth or a damp cloth that has been wrung out thoroughly. If the product is soiled or sticky, use a neutral detergent on a cloth then wipe with a damp cloth that has been wrung out thoroughly to remove any remaining detergent. Do not use benzine, thinner or alcohol as it may result in discoloration or deformation. Also pay close attention so as not to let the water and detergent come into contact with the cushions used in the product, it may result in deterioration. · When connecting or disconnecting the cable, make sure that you hold the plug, not the cable. Also, never place any heavy objects on the cable and never allow any sharp objects to come into contact with the cable. Applying excessive force to the cable may result in damage to the cable such as cutting the wires, etc. Plug has two black rings (The monaural type connector has one black ring. ) Output Level Adjustment Controls the level of the trigger output from the PC2602/65S. : Do not put excessive pressure on the level adjustment knob, it may result in damage. The switch functions described above will not function with a monaural phone cable. (Only the voice assigned to the pad can be produced. ) Since the PC2602 does not incorporate a edge switch, use of a monaural phone cable is allowed. Troubleshooting If the following trouble occurs when the PC2602/65S is used, please check the following points before asking your dealer for assistance. Specifications PC2602 Size Weight Sensor System PC2602S No Sound, Volume is Low Problem Is the PC2602/65S properly connected to the DTX Series Drum Trigger Module's input jack using the supplied stereo phone cable?Is the Level Adjustment Screw on the PC2602/65S set too low? 312(W) X 245(D) X 46. 5(H) mm 620g Trigger Sensor (Piezo) x 1 / Trigger Sensor (Piezo) x 1 Edge Switch x 1 Standard Monaural Phone Jack Standard Stereo Phone Jack (stereo) What to check Refer to the previous "Connections" section and make sure that all connections are proper. Output Jack * Improvements may result in a change in the specifications and/or design of the product without notice. If the Level Adjustment Screw is set too low, the single produced by the pad will be too low to produce sufficient volume from the drum trigger module's tone generator even though the pad is struck. Check the connections between the external device and the position of the power switch and volume level. Is the module properly connected to a pair of headphones or an external audio device such as an amplifier, speaker, etc. ?Are module settings correct? SPECIAL MESSAGE SECTION Check the volume setting of the voice assigned to the input to which the PC2602/65S is connected (refer to the previous "Adjusting the Voice Volume" section) or that the volume level for the headphones is not set too low, etc. NOTICE: Service charges incurred due to a lack of knowledge relathing to how a function or effect works (when the unit is operating as designed) are not covered by the manufacturer's warranty, and are therefore the owners responsibility. Please study this manual carefuly and consult your dealer before requesting service. ENVIRONMENTAL ISSUES: Yamaha strives to produce products that are both user safe and environmentally friendly. We sincerely believe that our products and the production methods used to produce them, meet these goals. [. . . ] In keeping with both the letter and the spirit of the law, we want you to be aware of the following: Warning: Do not attempt to disassemble. The Choke function doesn't work. Problem Is the pad type for the module Input to which the PC2602S is connected set to anything other than cymbal pad? What to check The choke function is unavailable if the pad type is set to anything other than cymbal pad. Disposal Notice: Should this product become damaged beyond repair, or for some reason its useful life is considered to be at an end, please observe all local, state, and federal regulations that relate to the disposal of products that contain lead, plastics, etc. If your dealer is unable to assist you, please contact Yamaha directly. [. . . ]