User manual YAMAHA PCY65

[. . . ] Its unique design allows compact setup and realistic performance. To get the most out of your PCY65/65S, please read this Owner's Manual carefully. [. . . ] The pad's output level should be adjusted in regards to how hard you hit the pad, to adjust the pad's dynamic range, or to better match the pad to the type of DTX Series Drum Trigger Module (DTXPRESS/DTX/DTXTREME) you are using. Level Adjustment Screw NOTE: When the PCY65/65S is used with a DTX Series Drum Trigger Module, enter the module's Trigger Edit Mode and set the [PAD Gain] (pad input level) parameter so that the display reads 90-95% when the pad is struck ff. Refer to the Owner's Manual that came with your module for more information. Adjusting the Voice Volume To change the volume of the voice assigned to the PCY65/65S pad, use the [VOICE] edit mode in the DTX Series Drum Trigger Module. Please refer to the Owner's Manual that came with your module for more information. Replacing Worn Pads · After extended use, some of the parts used on the PCY65/65S will wear out or their quality will deteriorate (pad rubber, connecting jacks, etc. ). The life of these parts will vary depending upon the circumstances under which the PCY65/65S is used. · Please ask the dealer from whom you purchased the device about replacing worm parts. Part Names PCY65 Pad Connections Use the supplied stereo phone cable to connect the pad's output jack to the input jack PCY65S Level Adjustment Knob Pad Output jack (RIDE, CRASH, etc. ) on the DTX Series Drum Trigger Module (DTXTREME/DTX/ D T X P R E S S ) . I n s e r t t h e L - s h a p e d p l u g i n t o t h e O u t p u t Ja c k o n t h e underside of the PCY65/65S pad. Insert Output jack Edge (The PC65S is equipped with a built-in edge switch) The manner in which the PCY65 and PCY65S will function corresponds to the INPUT numbers on the DTX Series Drum Trigger Module shown in the chart below. Setting Up First setup the rack system (Yamaha RS70, etc. ) or a commercially available cymbal stand (Yamaha CS series, etc. ) and then attach the PCY65/65S as shown in the illustration. Felt Wing Nut * Make sure you set the module's pad type setting to cymbal. (Refer to the Owner's Manual that came with your module. ) A single voice can be assigned to, and produced by the pad. Independent voices can be assigned to and produced by the pad and edge section (Dual Zone; The cup and pad sections share the same voice). A choke function (grabbing the edge section stops the voice being produced by the pad) is also available. A mute function (holding the edge section produces an alternate sound when the pad is hit) is also available. 1. First, insert the stopper underneath the cymbal support, and then use a drum key (optional) to secure. Make sure that the rod on the stopper is inserted into the hole on the upper portion of the PCY65/65S. NOTE: The Stopper is used to prevent the cymbal pad from rotating during performance and allow setting of the cymbal pad to any angle. [. . . ] The model number, serial number are located on this plate. You should record the model number, serial number, and the date of purchase in the spaces provided below and retain this manual as a permanent record of your purchase. Model : PCY65 Serial No. [. . . ]