User manual YAMAHA PF10

[. . . ] To change the setting use a "minus" screwdriver to rotate the selector dial so that the correct voltage appears next to the pointer on the panel. Introduction SPECIAL MESSAGE SECTION PRODUCT SAFETY MARKINGS: Yamaha electronic products may have either labels similar to the graphics shown below or molded/stamped facsimiles of these graphics on the enclosure. The explanation of these graphics appears on this page. Please observe all cautions indicated on this page and those indicated in the safety instruction section. Battery Notice: This product MAY contain a small non- rechargable battery which (if applicable) is soldered in place. [. . . ] Make sure to store the recorded data by pressing the [I] (SAVE) button (page 44). I Measure/Beat/Clock Measure 1 Beat Clock 1 2 3 4 000- 000- 000- 0001919 1919 1919 1919 2 1 2 3 4 000- 000- 000- 0001919 1919 1919 1919 I Velocity The table below shows the available settings and the corresponding velocity values. Kbd. Vel Actual playing strength fff 127 ff 111 f 95 mf 79 mp 63 p 47 pp 31 ppp 15 I Gate Time The following settings are available: Normal . . . . . . . . . . . . . . . . . . . . . . . The gate time (note length) can be specified as a percentage by using the [DATA ENTRY] dial. PF-1000 95 Recording Your Performances and Creating Songs-- Song Creator Recording Melodies -- Step Record (Note) In this section, we'll show you how to use Step Recording by guiding you through this actual music example, shown at right. The operations here apply to step 6 on page 95. 1 1-1 1-2 While holding down this note. . . Select this note. 1-3 . . . press this (to input a tie). The notation display on the instrument may not be accurate, especially for tied notes or longer notes. To have the notation displayed accurately, set the gate time to tenuto by using the [H] button, and input the notes as desired. 2 2-2 2-3 2-4 2-1 Select this note. 3 3-1 Press this button to display the dotted notes. 3-3 3-2 Select this note. 4 4-1 4-3 Call up the normal notes by pressing this button. 4-2 Select this note. To input rests, simply move the measure/beat/clock location for the desired rest time, then input the next note. I Play back the newly created melody Use the [C] ( L ) button to move the cursor to the beginning of the song, and press the SONG [START/STOP] button to hear the newly entered notes. To actually enter the recorded data, press the [EXIT] button. The entered data can be edited from the SONG CREATOR (1 - 16) display (page 103). 96 PF-1000 Recording Your Performances and Creating Songs-- Song Creator Recording Chord Changes for the Auto Accompaniment -- Step Record (Chord) The Chord Step recording feature makes it possible to record auto accompaniment chord changes one at a time with precise timing. Since the changes don't have to be played in real time, you can easily create complex, tight chord changes -- over which you can record the melody in normal fashion. The operations here apply to step 6 on page 95. Entering Chords and Sections (Chord Step) For example, you can input the following chord progression by the procedure described below. MAIN A BREAK MAIN B C F G F G7 C Enter the chords by using the currently selected chord fingering method in the Auto Accompaniment section of the keyboard. 1 Press the MAIN [A] button to specify the section, and enter the chords as shown at right. MAIN A C MAIN A B C D F G C 001:1:000 F 001:3:000 Select this note value and play the chords indicated at right. G 002:1:000 2 Press the [BREAK] button to specify the Break section, and enter the chords as shown at right. MAIN A BREAK C F G F G7 F 002:3:000 BREAK INTRO G7 002:4:000 Select this note value and play the chords indicated at right. PF-1000 97 Recording Your Performances and Creating Songs-- Song Creator 3 Press the MAIN [B] button to specify the section and enter the chord indicated at right. MAIN A BREAK MAIN B MAIN A B C D C F G F G7 C C 003:1:000 Select this note value and play the chords indicated at right. I Play back the newly created chord progression Use the [C] ( L ) button to move the cursor to the beginning of the song, and press the SONG [START/STOP] button to hear the newly entered notes. To actually enter the recorded data, press the [EXIT] button. The entered data can be edited from the SONG CREATOR (CHD) display (page 104). After the operation is completed, this button changes to [UNDO], letting you restore the original data if you're not satisfied with the Quantize results. The Undo function only has one level; only the previous operation can be undone. D I Calls up the SONG display, from which you can save the edited data. E J 1 2 3 4 5 6 7 8 Determines how strongly the notes will be quantized. If a value less than 100% is selected, notes will be moved toward the specified quantization beats only by the specified amount. Applying less than 100% quantization lets you preserve some of the "human" feel in the recording. Selects the desired channel to be quantized. Selects the quantize size (resolution). See the below for the details. I About Quantize Size Set the Quantize size to correspond to the smallest notes in the channel you are working with. For example, if the data was recorded with both quarter notes and eighth notes, use 1/8 note for the Quantize size. If you apply a 1/4 note Quantize size, the eighth notes would be moved on top of the quarter notes. One measure of eighth notes before quantization After 1/8 note quantization Quantize Size 1/4 note 1/8 note 1/16 note 1/32 note 1/16 note + 1/8 note triplet * 1/16 note + 1/16 note triplet * 1/4 note triplet 1/8 note triplet 1/16 note triplet 1/8 note + 1/8 note triplet * The three Quantize settings marked with asterisks (*) are exceptionally convenient, since they allow you to quantize two different note values at the same time, without compromising the quantization of either one. For example, if you have both straight 1/8 notes and 1/8 note triplets recorded to the same channel, and you quantize to straight 1/8 notes, all notes in the channel are quantized to straight 1/8 notes -- completely eliminating any triplet feel in the rhythm. However, if you use the 1/8 note + 1/8 note triplet setting, both the straight and triplet notes will be quantized correctly. 100 PF-1000 Recording Your Performances and Creating Songs-- Song Creator Delete This lets you delete recorded data in the specified channel. Use these to select the desired edit operation. A F B G C H Deletes all data in the selected channel. After the operation is completed, this button changes to [UNDO], letting you restore the original data. [. . . ] De C. V. , Departamento de ventas Javier Rojo Gomez No. 1149, Col. Tel: 686-00-33 KOREA Yamaha Music Korea Ltd. 16F 23-8 Yoido-dong, Youngdungpo-ku, Seoul, Korea Tel: 02-3770-0661 SWEDEN Yamaha Scandinavia AB J. Wettergrens Gata 1 Box 30053 S-400 43 Göteborg, Sweden Tel: 031 89 34 00 MALAYSIA Yamaha Music Malaysia, Sdn. , Bhd. [. . . ]