User manual YAMAHA PHAZER GT-2007

[. . . ] SNOWMOBILE OWNER'S MANUAL PZ50FXW PZ50GTW PZ50MW PZ50VTW LIT-12628-02-60 8GK-28199-10 A ESU00286 1- MACHINE IDENTIFICATION Identification number records A. ENGINE NUMBER (PRIMARY ID): CZ-01E C. KEY NUMBER: C CZ-01E Record the frame number, engine number (Primary ID), and key number in the spaces provided for assistance when ordering spare parts from a Yamaha dealer. 1 The frame number is the seventeen-digit number stamped on the frame of the snowmobile. [. . . ] An overheated track will be weakened internally, which may cause failure or damage. Off-trail riding Avoid off-trail riding until there is sufficient snow coverage. It generally takes several feet of snow to provide a good overall base to properly cover debris, such as rocks, logs, etc. If snow coverage is not sufficient, stay on trails to avoid impact damage to the drive track. Studded track In general, track life will be shortened when studs are installed. Drilling stud holes into the drive track will cut the internal fibers, which weakens the track. Studs may catch on an object and pull out of the track, leaving tears and damage around the already weakened area. To minimize possible damage, consult your stud manufacturer for installation and stud pattern recommendations. Yamaha does not recommend track studding. 7-7 ESU02450 Strap For PZ50M The strap 1 should be used only by experienced operators to assist them when traverse (side-hill) riding. WARNING @ Improper use of the strap on the handlebar can result in severe injury or death. G Use the strap only as an operator grip point when needed to shift weight uphill to maintain balance during traverse (side-hill) riding. Only experienced operators should traverse slopes steep enough to require strap use. G Keep the right hand on the right handlebar grip for steering, and grip the strap with the left hand to shift weight uphill for balance during traverse riding. G Ride cautiously while using the strap. Do not accelerate or decelerate abruptly while holding onto the strap. G Do not use the strap to lift the snowmobile. G Do not use the strap as a mounting point for cargo or accessories. @ ESU05520 Driving WARNING @ Be sure to read the "SAFETY INFORMATION" and "Riding your snowmobile" sections carefully before operating the snowmobile. @ NOTE: @ Make sure that the engine is warmed up enough before riding. @ 7-8 1. While the engine is idling, select the desired operating position by pressing the drive select switch 1. Make sure that the drive "D" indicator light 2 or the reverse "R" indicator light 3 flashes, and then comes on and remains on. NOTE: @ Once the indicator light for the selected position comes on and remains on, the snowmobile can be driven. If the indicator light keeps flashing, the snowmobile is not correctly shifted into drive or reverse. Apply a little throttle, and then press the drive select switch again. @ 1 Drive select switch 2 Drive "D" indicator light 3 Reverse "R" indicator light WARNING @ G G G G @ Make sure that the throttle lever is fully released and the snowmobile is at a full stop before shifting. Be sure to press the drive select switch only while the engine is idling. Make sure that the area behind the snowmobile is clear before reversing. [. . . ] Battery Remove the battery from the snowmobile. Store it in a cool, dry place that is above 0 °C (32 °F), but less than 30 °C (90 °F). Check the condition of the battery once a month, and charge it as necessary. WARNING @ G G G @ Never smoke around the battery while it is being charged. Sparks may ignite the hydrogen gas created by the battery. [. . . ]