User manual YAMAHA PM-3000

[. . . ] If you turn on the HA+CH button, using the [RECALL SAFE] key of the panel or the RECALL SAFE button in the CH VIEW screen (INPUT VIEW function) to turn Recall Safe on/off will now also turn on/off the Recall Safe setting for the HA patched to the corresponding channel. If the CH button is on, the HA Recall Safe setting will not be linked. Switch parameter value indication on/off in the Name display A "CHANNEL NAME NUMERIC DISPLAY" field has been added to the PREFERENCE 2 screen. [. . . ] If the CH button is on, the HA Recall Safe setting will not be linked. Switch parameter value indication on/off in the Name display A "CHANNEL NAME NUMERIC DISPLAY" field has been added to the PREFERENCE 2 screen. In V1. 04 and earlier, operating the fader or encoder (pan setting) of each channel caused the name display to show the value of that parameter. In V1. 05, turning the "ENCODER VALUE" and "FADER VALUE" options off will prevent the respective parameter value from appearing when you operate the fader or encoder. DCA group name Recall Safe and Selective Recall can be switched on/off A new WITH NAME button has been added to the DCA area of the RECALL SAFE screen and SELECTIVE RECALL screen. This allows you to exclude just the DCA group name from DCA group Recall Safe and Selective Recall. If the WITH NAME button is on, Recall Safe and Selective Recall will apply to the DCA group names of DCA groups for which these functions are on. However, SETUP data created on system software V1. 03 or earlier can be loaded by a system that's running V1. 05 or later. A note regarding scenes/libraries immediately after system startup After the system is started up, the PM5D takes several minutes to transfer scene/library data within internal memory. (The time required depends on the amount of data. ) This means that the following restrictions apply during this time. · You can't execute the PASTE button in the GLOBAL PASTE screen. · You can't execute the scene memory UNDO function. · Scene memory recall will take a bit of time. Note Before turning on the MONITOR button, you must select the same port as the monitor output on the DME series unit and as the monitor input for the PM5D. [. . . ] · You can't execute the scene memory UNDO function. · Scene memory recall will take a bit of time. Note Before turning on the MONITOR button, you must select the same port as the monitor output on the DME series unit and as the monitor input for the PM5D. [. . . ]