User manual YAMAHA PM1800

[. . . ] 7 Channel name area added to the EQ CH and LCR screens. 11 Input Channel Auto Naming procedure . 18 Extended functionality for Recall Safe. 21 Recall Safe is now possible for compressor and gate . [. . . ] While the meter bridge shows the input channel or ST IN channel levels, the panel switches in the METER section will operate differently, as follows. · The METER [PRE] switch cannot be operated. However if PRE ATT/PRE GATE / PRE FADER is selected as the metering point, the METER [PRE] switch LED will blink. · While the METER screen IN PEAK HOLD button is on, the METER [PEAK HOLD] switch LED will blink. 32 Parameter Lock/Console Lock Parameter Lock/Console Lock In V1. 6, the user can specify a password, and disable changes in specified parameters (Parameter Lock) or prohibit console operations (Console Lock) until the correct password is input. This function is a convenient way to prevent an unauthorized third party from tampering with the console while the engineer is resting. There are two types of password; a "system password" that is common to the entire system, and a "console password" that can be set for the individual console. Specifying the system password allows you to use the Parameter Lock and Console Lock functions. Specifying the console password allows you to use only the Console Lock function. SECURITY screen A SECURITY screen has been added to the UTILITY function, allowing you to input passwords and enable or defeat Parameter Lock or Console Lock. 1 2 3 2 PARAMETER LOCK When you turn this button on, the parameters selected in the LOCK PARAMETER SELECT area (4) will be locked. If not even one parameter has been selected, this button will be grayed-out, and cannot be turned on. 3 CONSOLE LOCK This button locks the console. You must input the System Password in order to use this button to enable/defeat Console Lock. 1 SYSTEM PASSWORD This specifies the password for the entire system. Changing the input patch settings · OUTPUT PATCH. . . . . . . . . . Changing the output patch settings · INPUT CH ON/OFF. . . . . Switching input channels on/off · OUTPUT CH ON/OFF. Switching output channels on/off · MIX TO ST ON/OFF . . . . Operating the MIX [TO ST] switch of a MIX channel · DCA MUTE ON. . . . . . . . . . . . Turning on the DCA [MUTE] switch Hint Even if parameters are locked, recalling a scene will generally disable the lock, and the settings will be overwritten by the recalled content. However, the following exceptions apply. · If a scene is recalled while input patch/output patch is locked, the patch settings will not change. · If a scene is recalled while dither settings are locked, the unit dither settings will not be recalled. · If a unit library or scene with different unit assignments is recalled, the unit/patch settings will be overwritten by the recalled content regardless of the parameter lock setting. · When you undo a scene recall, the input patch, output patch, and dither settings will be undone regardless of the parameter lock setting. [. . . ] If a parameter with a resolution of greater than 7 bits is assigned to a control number in the range of 1­31, that control number +32 can be assigned as the LSB of the same parameter. STATUS 1011nnnn 0ccccccc 0vvvvvvv Bn cc vv Control Change Control No. (1-5, 7-31, 3337, 39-95, 102-119) Value 60 h (INC) and 61 h (DEC) are not supported. 1. 1. 4 PROGRAM CHANGE (Cn) <Reception> If [Program Change Rx] is ON, this message can be received at the MIDI IN for which reception is enabled, if the [Rx CH] matches in the case of SINGLE mode. However if [OMNI] is ON, this message will be received regardless of the channel. In the case of MULTI mode, all MIDI channels will be received, and will be divided into banks according to the channel. If [Program Change ECHO] is ON, this message will be echoed. [. . . ]