User manual YAMAHA PM1DMANAGER

[. . . ] PM1D Manager V2 for Windows Owner's Manual About the specifications of this software Specifications of this software and the material given in this manual are subject to change without notice. Copyright Copying or distributing this software and/or this manual in part or in whole using any method without the written permission of Yamaha Corporation is prohibited. Trademarks Windows is a registered trademark of Microsoft Corporation in the United States and other countries. Pentium II is a registered trademark of Intel Corporation. [. . . ] · UPLOAD The current settings of PM1D Manager will be transmitted to the console/engine, and then synchronized operation will begin. · DOWNLOAD The current settings of the console/engine will be transmitted to PM1D Manager, and then synchronized operation will begin. Whether PM1D Manager is online or offline can be verified by the state of the ONLINE/OFFLINE button in the Function menu screen. 4. In the Communication Port field, select the port that you will be using, and click the OK button. If the system includes a console, click the PERMIT button in the PC CONNECTION area of the console's SYSTEM CONNECTION screen. This will allow a PC connection with the connected console/ engine. Offline (connection not possible) Offline (connection possible) Online In a state in which it is not possible to initiate communications, the OFFLINE/ONLINE button will be grayed, and cannot be clicked. In this case, please check the cable connections and settings. For details, refer to "CS1D Reference Manual (Software)" contained in the CS1D Owner's Manual SYS/ W. CLOCK function. Hint · If you are using Mirror mode, you can communicate only with the selected engine A or B. The PERMIT button for the unused engine cannot be turned on from the PC CONNECTION screen. · If you are using Dual Console mode, you can communicate only with console 1. The console 2 PERMIT button will not appear in the PC CONNECTION screen. Also, you cannot operate the various PERMIT buttons from console 2. · Only one PC can be connected to a system. It is not possible to connect multiple PC's to a system. The PERMIT button in the PC CONNECTION screen can be turned on either (not both) for the console or the engine that is being used (ENGINE A or B). If you are using cascade connection, master and slave are handled separately, so this is considered as two systems. When you click either UPLOAD or DOWNLOAD in the "CONNECTION" popup window to select the connection mode, please check the following points. · In the console's SYS/W. CLOCK screen PC CONNECTION area, make sure that the PERMIT button of the device connected to the PC is turned on. · Make sure that no popup window is displayed in the screen of the console. · Make sure that no file is being loaded on the console. · Make sure that time code is not running in the system. · Auto fading or manual fading are not in progress. If any of the above conditions are not satisfied, a popup window will appear, informing you that the PC cannot be connected to the other device, and the connection procedure will be aborted at step 4 above. Communication may become unstable if the cable is too long. [. . . ] The USB connector of the console/engine is located in the PC CONTROL section of the rear panel. Select "Install software automatically (recommended) (I), " and then click Next. The driver is installed, and the message "Completing the Found New Hardware Wizard" appears. Click Finish, and then restart your PC. 22 USB MIDI Driver Troubleshooting Cannot control the console/engine via USB · Have you installed the Yamaha USB MIDI driver (see page 22)? [. . . ]