User manual YAMAHA PM5DV110

[. . . ] If the CH button is on, the HA Recall Safe setting will not be linked. Switch parameter value indication on/ off in the Name display A "CHANNEL NAME NUMERIC DISPLAY" field has been added to the PREFERENCE 2 screen. In V1. 04 and earlier, operating the fader or encoder (pan setting) of each channel caused the name display to show the value of that parameter. In V1. 05 and later, turning the "ENCODER VALUE" and "FADER VALUE" options off will prevent the respective parameter value from appearing when you operate the fader or encoder. DCA group name Recall Safe and Selective Recall can be switched on/off A new WITH NAME button has been added to the DCA area of the RECALL SAFE screen and SELECTIVE RECALL screen. [. . . ] · Data will be stored/recalled as scene data, but the Undo function is not supported. · If you power-off and then power-on the PM5D, conventional scene data will be in the same state as when EN · · · · you powered-off, but the Y96K will be in the state that was last stored or recalled. If you recall a scene that produces a major change in the settings of the Y96K, the settings of the Y96K will change several seconds after recall occurs on the PM5D. If you want the timing of the change to be synchronized, use the FADE TIME screen to specify a START OFFSET. Do not perform scene store/recall operations in the Y96K's update waiting screen. If you do so, the screen will become inoperable for up to 30 seconds. The Scene Store operation saves the Y96K settings in the PM5D. If you executed Scene Store while the Y96K had previously been installed, and then once again store the scene with the Y96K not installed, the previous Y96K settings will remain. If a scene has never been stored while the Y96K is installed, recalling that scene with the Y96K installed will not affect the Y96K in any way. In PREVIEW mode, the PLUG-IN screen does not display the Y96K status. Newly added bulk dump data types The following data types can now be handled by bulk dump. Data name (D0) Data Number (D1, 2) tx/rx Function `K' `V' `L' `U' 512 Surround Setting tx/rx (Current Data) & Request 512User Defined Keys tx/rx (Current Data) & Request 512MIDI Remote & tx/rx (Current Data) Request 512Fader Mode & tx/rx (Current Data) Request SETUP data compatibility SETUP data created on system software V1. 05 or later cannot be loaded into a system that's running V1. 03 or earlier. However, SETUP data created on system software V1. 03 or earlier can be loaded by a system that's running V1. 05 or later. MIDI EVENT etc. data now maintained during scene recall The MIDI EVENT, GPI OUT CONTROL, and REMOTE TRANSPORT data included in a scene is now maintained when a scene recall occurs. This means that if you store a recalled scene into another scene, this data will be stored as it was when recalled. Scene data compatibility (from V1. 10) In conjunction with Y96K card support, compatibility of scene data (ALL DATA, SCENE MEMORY, SCENE MEMORY with LINKED LIBRARY) has been changed as follows. Scene data created with system software V1. 10 or later cannot be loaded into a system running V1. 04 or earlier. [. . . ] · You can't execute the scene memory UNDO function. · Scene memory recall will take a bit of time. Support for Studio Manager (PM5D Editor) (from V1. 10) Now you can use the included Studio Manager application software to control the PM5D. For details on Studio Manager, refer to the Studio Manager installation guide. Note Before turning on the MONITOR button, you must select the same port as the monitor output on the DME series unit and as the monitor input for the PM5D. [. . . ]