User manual YAMAHA PM5DV112

[. . . ] If the CH button is on, the HA Recall Safe setting will not be linked. Switch parameter value indication on/ off in the Name display (from V1. 05) A "CHANNEL NAME NUMERIC DISPLAY" field has been added to the PREFERENCE 2 screen. In V1. 04 and earlier, operating the fader or encoder (pan setting) of each channel caused the name display to show the value of that parameter. In V1. 05 and later, turning the "ENCODER VALUE" and "FADER VALUE" options off will prevent the respective parameter value from appearing when you operate the fader or encoder. DCA group name Recall Safe and Selective Recall can be switched on/off (from V1. 05) A new WITH NAME button has been added to the DCA area of the RECALL SAFE screen and SELECTIVE RECALL screen. [. . . ] · PAN MODE The PAN MODE parameter will be recalled. However, if the recall would cause the PAN MODE setting to change from BALANCE to some other setting, or from some other setting to BALANCE, then the PAN MODE and PAN parameters will not be recalled. Also, if the recall causes the PAN MODE to become GANG PAN, the relative difference of the PAN parameter values following the recall will be maintained when they are edited. · The Scene Store operation saves the Y96K settings in the PM5D. If you executed Scene Store while the Y96K had previously been installed, and then once again store the scene with the Y96K not installed, the previous Y96K settings will remain. If a scene has never been stored while the Y96K is installed, recalling that scene with the Y96K installed will not affect the Y96K in any way. · In PREVIEW mode, the PLUG-IN screen does not display the Y96K status. MIDI EVENT etc. data now maintained during scene recall (from V1. 05) The MIDI EVENT, GPI OUT CONTROL, and REMOTE TRANSPORT data included in a scene is now maintained when a scene recall occurs. This means that if you store a recalled scene into another scene, this data will be stored as it was when recalled. DME series monitor source selection and EXTERNAL CUE on/off (from V1. 05) A MONITOR button and monitor source select button have been added to the DME CONTROL screen. When you click the monitor source select button ( ), the MONITOR POINT SELECT window will appear, letting you select the DME series unit monitor source. If the MONITOR button is on, the EXTERNAL CUE indicator in the upper part of the display will turn on, and the monitor signal of the DME series unit will be sent to the PM5D's CUE bus. Support for the Y96K card (from V1. 10) A PLUG-IN screen has been added to the EFFECT function. Also, PLUGIN parameters have been added to the RECALL SAFE screen and SELECTIVE RECALL screen of the SCENE function. These additions are in order to support the Y96K card that will become available in the near future from the Waves Corporation. For details on operation, refer to the owner's manual for the Y96K. Please note that the Y96K card will operate as follows. · Data will be stored/recalled as scene data, but the Undo function is not supported. · If you power-off and then power-on the PM5D, conventional scene data will be in the same state as when you powered-off, but the Y96K will be in the state that was last stored or recalled. · If you recall a scene that produces a major change in the settings of the Y96K, the settings of the Y96K will change several seconds after recall occurs on the PM5D. If you want the timing of the change to be synchronized, use the FADE TIME screen to specify a START OFFSET. [. . . ] (The time required depends on the amount of data. ) This means that the following restrictions apply during this time. · You can't execute the PASTE button in the GLOBAL PASTE screen. · You can't execute the scene memory UNDO function. [. . . ]