User manual YAMAHA PS25

[. . . ] IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used. Failure to follow instructions could void your FCC authorization to use this product in the USA. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. [. . . ] 2) using the individual [REC SELECT] buttons. The Rehearsal function can be used with all three methods. Using the REC/PAUSE Button 1. Locate to a position before the point at which you want to punch in. Press the [REC SELECT] button of the track that you want to record. A circle flashes around the corresponding track indicator. Press the [PLAY] button to start playback. Playback starts and the PLAY indicator lights up. At the point where you want to punch in, press the [REC/PAUSE] button. The circle around the track indicator stops flashing and lights up continuously. If you're monitoring the track via CUE (i. e. , [FLIP] switch in the up position), you'll hear the existing sound playback until the [REC/PAUSE] button is pressed. After which you'll hear the new sound that's being recorded. Instead of pressing the [REC/PAUSE] button you could have pressed the [REHE] button to engage Rehearse mode. The circle around the track indicator flashes. Through the CUE monitor (i. e. , [FLIP] switch in the up position) you'll hear the existing sounds playback. Instead of pressing the [PLAY] button you could have pressed the [REC SELECT] button to punch out. In this case, the PS25 remains in Play Record Wait mode, so you can punch in again using the [REC SELECT] buttons. 7. Press the [STOP] button to stop playback. The following illustration shows how punch in/out works with the [REC SELECT] buttons. In Point 8 7 6 5 4 3 2 1 Out Point REC SELECT Record Pause REC/PAUSE PLAY Play Record Wait Record PLAY Play STOP REC SELECT 3 3 7 PS25--Owner's Manual Using a Footswitch 25 Using a Footswitch 1. Connect an optional footswitch to the PUNCH I/O jack. Locate to a position before the point at which you want to punch in. Press the [REC SELECT] button of the track that you want to record. A circle flashes around the corresponding track indicator. The REC/PAUSE indicator flashes, indicating Record Pause mode is engaged. Playback starts and the PLAY indicator lights up. [. . . ] Pre-Roll Point--This is the point before the actual punch in point at which the Auto Punch In/Out sequence starts. When the Auto Punch In/Out sequence is complete, PS25 rewinds automatically to the pre-roll point. Post Fader--A point in the signal path after a fader. The signals for the PS25 AUX controls are sourced post-fader. [. . . ]