User manual YAMAHA PSS-150

[. . . ] Turn on the power again only after the mixer cools, since it cannot be turned on until the internal temperature goes down. Reduce the volume with the MASTER LEVEL control so that the LIMITER indicator flashes only briefly in response to the highest transient peaks. 275 255 96. 3 137 120 2-M8x25 Features Two-way, 8-inch (20 cm) speaker system The built-in speakers deliver high-quality powerful sound from an exceptionally compact cabinet. The scratch-resistant speakers are rugged enough for outdoor use. 2. Use a screwdriver or coin to turn each screw on the mixer from LOCK to OPEN until it clicks. 2 3 c Is the vent on the top panel of the mixer blocked? Since inadequate ventilation can result in overheating the mixer, the protection circuit may come on automatically and the power may be turned off. [. . . ] 135 Milner Avenue, Scarborough, Ontario, M1S 3R1, Canada Tel: 416-298-1311 POLAND Yamaha Music Europe GmbH Branch Sp. z o. o. 17 Stycznia 56, PL-02-146 Warszawa, Poland Tel: 022-868-07-57 ASIA THE PEOPLE'S REPUBLIC OF CHINA Yamaha Music & Electronics (China) Co. , Ltd. 2F, Yunhedasha, 1818 Xinzha-lu, Jingan-qu, Shanghai, China Tel: 021-6247-2211 Power supply/Power cord · Only use the voltage specified as correct for the device. The required voltage is printed on the name plate of the device. · Use only the included power cord. · Do not place the power cord near heat sources such as heaters or radiators, and do not excessively bend or otherwise damage the cord, place heavy objects on it, or place it in a position where anyone could walk on, trip over, or roll anything over it. Water warning · Do not expose the device to rain, use it near water or in damp or wet conditions, or place containers on it containing liquids which might spill into any openings. · Never insert or remove an electric plug with wet hands. Reverb is not applied to the sound c Are the REVERB switches of each channels set to ON ( c Is the REVERB control set to an appropriate level? )? U. S. A. Yamaha Corporation of America 6600 Orangethorpe Ave. , Buena Park, Calif. These precautions include, but are not limited to, the following: Turning the power on/ off Caution c If you want to get a clearer sound for announcements, set the SPEECH/MUSIC switch to SPEECH ( BRAZIL Yamaha Musical do Brasil Ltda. Rua Joaquim Floriano, 913 - 4' andar, Itaim Bibi, CEP 04534-013 Sao Paulo, SP. BRAZIL Tel: 011-3704-1377 SPAIN/PORTUGAL Yamaha Música Ibérica, S. A. 17, 200, 28230 Las Rozas (Madrid), Spain Tel: 91-639-8888 Using a single speaker ·To avoid any loud, unexpected noise from the speakers, first turn on the power to those connected devices that are closest to the sound source. Yamaha cannot be held responsible for damage caused by improper use or modifications to the device. Always turn the power off when the device is not in use. The performance of components with moving contacts, such as switches, volume controls, and connectors, deteriorates over time. Consult qualified Yamaha service personnel about replacing defective components. Illustrations in this manual are for explanatory purposes only, and may not match the actual appearance of the product during operation. Company names and product names used in this Owner's Manual are trademarks or registered trademarks of their respective owners. (5)-3 c You can use a single speaker. If you use a single speaker, the mixer outputs just one channel of the stereo signal, left or right. Outputting the signal for monitoring c Connect a powered speaker to the MONITOR OUT jack. The MONITOR OUT jack outputs the signal prior to routing through the MASTER LEVEL control. Adjust the level of output signal from the MONITOR OUT jack with the MONITOR OUT control. The MONITOR OUT control does not affect the MASTER LEVEL control. [. . . ] For high-level signals (such as keyboard instruments and audio equipment), set the switch to the LINE ( ) position. L L R Use the REVERB control to adjust the overall reverb. R L L L R R L Controls and Functions AC IN jack Connect the included power cable here. Be sure to use the included power cord. Use of other cords may result in malfunction, heat generation, or fire. Caution SPEAKER L/R jacks (for included speakers only) These output the mixed signal channels from 1 to 7/8, and the level is adjusted with the MASTER LEVEL control. When connecting the included speakers, make sure to turn the power off first. Also, to avoid any possible malfunction, use only the included speakers and the speaker cables included with the device. Channel input jacks (CH 1 to 4) For connecting a guitar, microphone, keyboard or other instrument/device. [. . . ]