User manual YAMAHA PSS26

[. . . ] The company names and product names in this Owner's Manual are the trademarks or registered trademarks of their respective companies. The screen displays as illustrated in this Owner's Manual are for instructional purposes, and may appear somewhat different from the screens which appear on your computer. · · · This owner's manual is applicable to both the A5000 Editor and the A4000 Editor (for both Windows and Macintosh). The screen illustrations are mainly taken from the A5000 Editor for Windows, although and differences between versions are explained. This owner's manual assumes that you are already familiar with basic Windows/Macintosh operation. [. . . ] # NOTE Specifies the note number which will initialize the phase of PROGRAM LFO. This has no effect when MIDI synchronization is selected. $ VALUE Sets the values for STEP 1 through 16 of the step wave waveform. This has no effect on waves other than the step wave. % SLOPE Selects the method by which the step wave steps will be smoothly connected. This has no effect on waves other than the step wave. ^ TOTAL STEPS Sets the total number of steps for the step wave. Values for steps beyond the total step number have no effect. 12 Sample Edit Window The Sample Edit Window allows you to edit the parameters related to the A5000/A4000 sample banks or samples. The edited data are transmitted to the A5000/A4000 via MIDI in realtime. For information on each parameter, refer to the A5000/A4000 Owner's Manual. 1 2 3 4 1 The Toolbar This area includes the buttons controlling the Sample Edit Window (P. 24). 2 "MAP/OUT", "FILTER", "EG" and "LFO/MIDI/CONTROL" tabs Click the tabs to switch between the "MAP/OUT", "FILTER", "EG" and "LFO/MIDI/CONTROL" pages. ¡ RATE/TIME Sets the portamento rate or time. 15 LEVEL SCALING unit TM BREAK POINT Sets the note number for level scaling BREAK POINT 1, 2. £ LEVEL Sets the BREAK POINT 1, 2 volume level. OUTPUT unit ¢ LEVEL Sets the OUTPUT 1, 2 volume level. OUTPUT Selects the output destination of the sample or sample bank. Two independent stereo outputs are available for OUTPUT 1 and 2. 16 FILTER page 1 2 3 4 5 6 7 8 9 ) !) RELEASE RATE Sets the rate at which the cutoff frequency moves from the sustain level to the release level following note off. INIT LEVEL Sets the cutoff frequency offset value at the time of note on. @ ATTACK LEVEL Sets the cutoff frequency offset value at the attack level. # SUSTAIN LEVEL Sets the cutoff frequency offset value at the sustain level. $ RELEASE LEVEL Sets the cutoff frequency offset value at the release level. % RATE SCALING Determines how the filter EG rates vary according to the note played. ^ VELOCITYRATE Determines how the filter EG rates vary in response to the velocity of the played note. [. . . ] In the following example, the tone generator is an A5000 and its setups are applied to OMS. MIDI In: Select "A5000. " MIDI Out: Select "A5000. " 3. Click [OK] to close OMS Port Setup. 26 Troubleshooting If you encounter problems such as no sound output or abnormal behavior, verify the connections before checking the following. If you are using the A5000/A4000 Editor for Windows, refer to the XGworks(lite) owner's manual too. <Macintosh> The printer port is not recognized. · The printer port will not be recognized if AppleTalk is ON. [. . . ]