User manual YAMAHA PW2000M

[. . . ] This manual will give you an understanding of the operation, inspection, and basic maintenance of this motorcycle. If you have any questions concerning the operation or maintenance of your motorcycle, please consult a Yamaha dealer. The design and manufacture of this Yamaha motorcycle fully comply with the emissions standards for clean air applicable at the date of manufacture. Yamaha has met these standards without reducing the performance or economy of operation of the motorcycle. [. . . ] Adjust and lubricate chain with Yamaha chain and cable lube thoroughly. Check all chassis fitting and fasteners. Apply lithium-soap-based grease (all-purpose grease) lightly. Check engine idling speed and starter operation. 10 hours 20 hours 40 hours 80 hours THEREAFTER EVERY 40 hours 80 hours 160 hours 8 * Tires 2 3 4 Every ride 9 10 * * Wheel bearings Steering bearings 11 Drive chain 5 6 7 8 9 12 13 14 15 * Chassis fasteners Sidestand pivot * * Front fork Shock absorber assembly Carburetor 16 * 6-3 PERIODIC MAINTENANCE AND MINOR REPAIR INITIAL NO. ITEM CHECK OR MAINTENANCE JOB Check operation. Apply Yamaha chain and cable lube or engine oil 10W-30 lightly. Apply Yamaha chain and cable lube or engine oil 10W-30 lightly. Apply lithium-soap-based grease (all-purpose grease) lightly. Apply lithium-soap-based grease (all-purpose grease) lightly. 10 hours 20 hours 40 hours 80 hours THEREAFTER EVERY 40 hours 80 hours 160 hours 1 17 * Autolube pump 2 18 Transmission oil * * Control cables Throttle grip housing and cable Brake lever pivot shaft Brake pedal pivot shaft * * Cylinder head and exhaust system Spark arrester 3 19 4 5 6 7 8 9 20 21 22 23 24 NOTE: The air filter needs more frequent service if you are riding in unusually wet or dusty areas. 6-4 PERIODIC MAINTENANCE AND MINOR REPAIR EAU19603 Checking the spark plug The spark plug is an important engine component, which is easy to check. A slight tilt to the side can result in a false reading. Wait a few minutes until the oil settles, remove the oil filler cap, wipe the dipstick clean, insert it back into the oil filler hole (without screwing it in), and then remove it again to check the oil level. NOTE: The transmission oil should be between the minimum and maximum level marks. To change the transmission oil 2 1 1. Transmission oil drain bolt 3 4 5 6 7 8 9 1 2 3 4 1 1. If the oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. Insert the dipstick into the oil filler hole, and then tighten the oil filler cap. 1. Place an oil pan under the transmission to collect the used oil. Remove the oil filler cap and drain bolt to drain the oil from the transmission. Install the transmission oil drain bolt, and then tighten it to the specified torque. Tightening torque: Transmission oil drain bolt: 20 Nm (2. 0 m·kgf, 14. 5 ft·lbf) 1. Place the vehicle on a level surface and hold it in an upright position. NOTE: Make sure that the vehicle is positioned 6-7 4. [. . . ] 6-27 Troubleshooting chart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-28 V Vehicle identification number . . . . . . . . . . . . . . . . . . . . 9-1 P Parking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-4 Part locations. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]