User manual YAMAHA R-S201

[. . . ] 1 2 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install this sound system in a well ventilated, cool, dry, clean place - away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. For proper ventilation, allow the following minimum clearances around this unit. [. . . ] SLEEP A (power) Press SLEEP repeatedly to set the amount of time before this unit is set to standby mode. Each time you press SLEEP, the front panel display changes cyclically as shown below. BASIC OPERATION The SLEEP indicator blinks while setting the amount of time for the sleep timer. If the sleep timer is set, the SLEEP indicator on the front panel display lights up. Y To cancel the sleep timer, do one of the following: – Select “SLEEP OFF”. English 13 En FM/AM TUNING Notes • The radio frequencies differ depending on the country or region where this unit is being used. Front panel display illustrations shown in this section are based on Europe model. € Only for Asia and General models: Be sure to set the tuner frequency step according to the frequency spacing in your area before you tune into a radio station (see page 19). Using preset functions You can register up to 40 radio stations as presets. Once you have registered stations, you can easily tune in to them by recalling the presets. FM/AM TUNING jj / ii ■ Presetting stations automatically (FM stations only) You can automatically register FM stations that have strong signals. Notes • If a station is registered to a preset number that already has a station registered to it, the previously registered station is overwritten. € If the station you want to store is weak in signal strength, press TUNING jj / ii repeatedly to tune in to the desired station. € Only for Europe model: Only Radio Data System broadcasting stations can be preset automatically. 1 2 Press FM/AM to select TUNER as the input source and select the band. When this unit tunes in to a station, the TUNED indicator lights up on the front panel display. Y FM stations registered as presets using the automatic preset registration feature will be heard in stereo. Note If the tuning search does not stop at the desired station because the station signals are weak, press TUNING jj / ii repeatedly to tune in to the desired station. FM y You can also use the buttons on the front panel if they have the same or similar names as those on the remote control. PRESET j / i ■ Improving FM reception If the signal from the station is weak and the sound quality is not good, set the FM band reception mode to monaural mode to improve reception. Front panel Press FM MODE, and then make sure the ST indicator is turned off (see page 4). The Option menu for TUNER is displayed (see page 19). [. . . ] 100 dB or more • Residual noise (IHF-A network) . 00 MHz * Specifications are subject to change without notice. Information for Users on Collection and Disposal of Old Equipment and Used Batteries ADDITIONAL INFORMATION These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. [. . . ]