User manual YAMAHA RS75

[. . . ] · Do not use or keep the product in places with extremely high temperature (places in direct sunlight, close to a heater, in a closed car, etc. ) or damp (bathroom, outside on a rainy day, etc. ). It may result in deformation, discoloration, stickiness, damage or deterioration. · To clean the product, please wipe with a soft cloth or a damp cloth that has been wrung out thoroughly. [. . . ] Loose bolts may result in the rack overturning or parts dropping causing injury. When adjusting the height or angle, do not suddenly loosen the bolt. The pad may drop, the rack or pipes may slip, pinching or causing injury to hands or fingers. The rack may overturn or be damaged resulting in injury. Please be careful when children are close to or touching the product. The product has many pipes and arms so careless movement around the product may result in injury. When setting the pads and modules, please pay close attention in regards to the handling and setting of cables. Feet may become entangled in the cables resulting in falls. Cable Band (x10) CAUTION If this symbol is ignored and the equipment is used improperly, there is a danger of injury to persons handling the equipment, and material damage could occur. Do not put your hands or feet under the foot pedal or foot switch. They may be pinched resulting in injury. Watch your fingers when adjusting clamps. They may become pinched resulting in injury. Be careful around pipe ends, inside the pipe and screw ends. Do not attach acoustic drums to the electronic drum rack. Clamps may be damaged and drums may drop, causing injury. Assembly Instructions (this sheet) Rubber Foot (x2) * Specifications are subject to change without notice. RS75 Assembly * Parts for the RS75's main structure have already been assembled before packing. After removing the unit from the box, follow the instructions described below to complete the assembly. A Phillips (+) screwdriver is required when attaching the Drum Trigger Module. [. . . ] (Please refer to the Owner's Manual that came with the cymbal pads on attaching the cymbal pads. ) Drum Trigger Module Module Holder Step 3-1 Step 3-2 Holder Clamp Cymbal Pad (PCY130/130S/150S) 5 Attaching the drum pads Attach drum pads to the hexagonal rod cylinder and adjust their position, the secure in place. Anti-swivel brace (supplied with the (PCY130/130S/150S) Make sure all bolts on clamps, pads, etc. , are firmly tightened. Loose or over-tightened bolts may result in the part falling off and/or damage. After assembly is complete, setup the kick pad, real hi-hat pad, etc. , and connect the cables. [. . . ]