User manual YAMAHA RX-V1200RDS

[. . . ] G RX-V1200 RDS AV Receiver Ampli-Tuner Audio-Video OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 1 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install this unit in a well ventilated, cool, dry, clean place with at least 30 cm on the top, 20 cm on the right and left, and 10 cm at the back of this unit -- away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. Locate this unit away from other electrical appliances, motors, or transformers to avoid humming sounds. [. . . ] · The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit. A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about the outdoor antennas. 36 TUNING Automatic and Manual Tuning There are 2 ways of tuning; automatic and manual. Automatic tuning is effective when station signals are strong and there is no interference. When using the remote control to proceed some of the steps in "TUNING", make sure the "TUNER" mode is selected. 4 Press PRESET/TUNING l / h once to begin automatic tuning. Press h to tune in to a higher frequency, or press l to tune in to a lower frequency. Press the same button again if the tuning search does not stop at the desired station. PRESET/ TUNING VCR 1 CBL/SAT D TV/LD DVD MD/TAPE CD R TUNER TUNED INTRODUCTION CD I Automatic tuning 1 INPUT VOLUME 6CH INPUT SP A A AM 1404 When tuned in to a station, the "TUNED" indicator lights up and the frequency of the received station is shown on the front panel display. PREPARATION INPUT M0DE NATURAL SOUND AV RECEIVER y · Use the manual tuning method if the tuning search does not stop at the desired station because the signal is weak. D I G I TA L PRO LOGIC STANDBY /ON A/B/C/D/E PRESET/ TUNING PRESET /TUNING FM/AM MEMORY TUNING MODE RDS MODE /FREQ BASS EON PTY SEEK TREBLE SPEAKERS A B PROCESSOR BASS DIRECT EXTENSION TUNER EDIT PHONES MAN'L/AUTO FM AUTO/MAN'L MONO S VIDEO VIDEO L AUDIO R MODE START OPTICAL STEREO PROGRAM DSP EFFECT I Manual tuning + SILENT VIDEO AUX ­ + ­ If the signal from the station you want to select is weak, you must tune in to it manually. BASIC OPERATION 1 4 23 Select TUNER and the reception band following steps 1 and 2 described in "Automatic tuning" on left. Press TUNING MODE (AUTO/MAN'L MONO) so that the "AUTO" indicator goes off from the front panel display. TUNING MODE 1 Press INPUT l / h (TUNER on the remote control) to select TUNER as the input source. INPUT POWER STANDBY SLEEP 6CH INPUT 2 or Front panel A PHONO TUNER CD AUTO ADVANCED OPERATION V-AUX CBL/SAT MD/TAPE CD-R AUTO/MAN'L MONO Goes off D-TV/LD VCR 1 VCR2/DVR DVD Remote control If the colon (:) appears on the front panel display next to the band indication, press PRESET/TUNING EDIT to turn it off. PRESET /TUNING VCR 1 CBL/SAT D TV/LD DVD MD/TAPE CD R TUNER TUNED 2 Press FM/AM to select the reception band. "FM" or "AM" appears on the front panel display. FM/AM CD EDIT SP A A AM 1404 ADDITIONAL INFORMATION or 3 3 Press TUNING MODE (AUTO/MAN'L MONO) so that the "AUTO" indicator lights up on the front panel display. TUNING MODE Press PRESET/TUNING l / h to tune in to the desired station manually. PRESET/ TUNING Hold down the button to continue the tuning search. AUTO/MAN'L MONO AUTO Lights up Note · Manually tuning in to an FM station will automatically change the reception mode to monaural to increase the signal quality. APPENDIX If the colon (:) appears on the front panel display next to the band indication, press PRESET/TUNING EDIT to turn it off. PRESET /TUNING VCR 1 CBL/SAT D TV/LD DVD MD/TAPE CD R TUNER TUNED CD EDIT SP A A AM 1404 English 37 TUNING Presetting Stations I Automatically presetting stations (for FM stations) You can use the automatic preset tuning feature to store FM stations. This function enables this unit to automatically tune in to FM stations with strong signals, and to store up to 40 (8 stations x 5 groups) of those stations in order. This feature enables you to easily tune in to any preset station by selecting the preset station number (see page 40). INPUT VOLUME 6CH INPUT Notes · Any stored station data existing under a preset number is cleared when you store a new station under that preset number. · When a station data is stored under a preset number, the frequency and reception band are also stored. · You can manually replace a preset station with another FM or AM station by simply following the procedure in the section "Manually presetting stations" on page 39. · If the number of the received stations does not reach E8, automatic preset tuning has automatically stopped after searching all stations. · Only FM stations with sufficient signal strength are stored automatically by automatic preset tuning. If the station you want to store is weak in signal strength, tune in to it manually in the monaural mode, and store it by following the procedure in "Manually presetting stations" on page 39. INPUT M0DE NATURAL SOUND AV RECEIVER D I G I TA L PRO LOGIC STANDBY /ON A/B/C/D/E PRESET/ TUNING PRESET /TUNING FM/AM MEMORY TUNING MODE RDS MODE /FREQ BASS EON PTY SEEK TREBLE SPEAKERS A B PROCESSOR BASS DIRECT EXTENSION TUNER EDIT PHONES MAN'L/AUTO FM AUTO/MAN'L MONO S VIDEO VIDEO L AUDIO R MODE START OPTICAL STEREO PROGRAM DSP EFFECT SILENT VIDEO AUX ­ + ­ + 132 1 Press FM/AM to select the FM band. FM/AM Automatic preset tuning options You can select the preset number from which this unit will store FM stations and/or begin tuning toward lower frequencies. Press A/B/C/D/E and PRESET/TUNING l / h (A/B/ C/D/E and PRESET j / i on the remote control) to select the preset number under which the first station will be stored. Automatic preset tuning will stop when stations have all been stored up to E8. Press PRESET/TUNING EDIT to turn off the colon (:) and then press PRESET/TUNING l to begin tuning toward lower frequencies. Memory back-up The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the preset stations may be cleared. [. . . ] and Australia models] . . . . . . . . . . . . . . . . . . . . . . . . . 1 (100 W maximum) · Dimension (W x H x D) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 435 x 171 x 432 mm (17-1/8" x 6-3/4" x 17") · Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 kg (33 lbs) · Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]