User manual YAMAHA RX-V363

[. . . ] G RX-V363 AV Receiver Ampli-tuner audio-vidéo OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING GEBRUIKSAANWIJZING CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. Caution: Read this before operating your unit. 1 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2 Install this sound system in a well ventilated, cool, dry, clean place ­ away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. Allow ventilation space of at least 30 cm on the top, 20 cm on the left and right, and 20 cm on the back of this unit. [. . . ] · Press Jl to decrease the value. Press LMENU to exit from set menu. 1 SOUND MENU 6 7 English 45 En Set menu 1 SOUND MENU Use this menu to manually adjust any speaker settings or compensate for video signal processing delays when using LCD monitors or projectors. A)SPEAKER SET Use this feature to manually adjust any speaker settings. FRONT B speaker setting FRONT B Use this feature to select the location of the front speakers connected to the FRONT B terminals. Choices: FRONT, ZONE B · Select "FRONT" to turn FRONT A and B on and off when the FRONT B speakers are set in the main zone. · Select "ZONE B" if the speakers connected to the FRONT B terminals are set in another zone. If FRONT A is turned off and FRONT B is turned on, all the speakers including the subwoofer in the main zone are muted and this unit outputs sound at the FRONT B terminals only. Notes · If you connect headphones to the PHONES jack on this unit, the sound is output from both headphones and the FRONT B terminals when "FRONT B" is set to "ZONE B". · If a DSP program is selected when "FRONT B" is set to "ZONE B", this unit automatically enters the Virtual CINEMA DSP mode (see page 36). Woofer section of a speaker is 16 cm (6. 5 in) or larger: large Woofer section of a speaker is smaller than 16 cm (6. 5 in): small Front speakers FRONT Choices: LARGE, SMALL When the front speakers are large Select "LARGE" (large). When the front speakers are small Select "SMALL" (small). Note When "BASS OUT" is set to "FRNT" (see page 47), you can select only "LARGE" in "FRONT". If the value of "FRONT" is set to a setting other than "LARGE" in advance, this unit automatically changes the value to "LARGE". Speaker settings Center speaker CENTER Choices: NONE, SML, LRG When the center speaker is large Select "LRG" (large). When the center speaker is small Select "SML" (small). When you do not use the center speaker Select "NONE" (none). The center channel signals are directed to the front left and right speakers. LR Choices: NONE, SML, LRG When the surround speakers are large Select "LRG" (large). When the surround speakers are small Select "SML" (small). When you do not use the surround speakers Select "NONE" (none). This unit is set to the Virtual CINEMA DSP mode (see page 36). 46 En Set menu LFE/Bass out BASS OUT Use this feature to select the speakers that output the LFE (low-frequency effect) and the low-frequency signals. Choices: SWFR, FRNT, BOTH y If you are not satisfied with the bass sounds from your speakers, you can change these settings according to your preference. Speaker level B)SP LEVEL Use this feature to manually adjust the output level of each speaker. Control range: ­10 to +10 dB Control step: 1 dB Initial setting: 0 dB SP LEVEL Adjusted speaker Front left speaker Front right speaker Center speaker Surround left speaker Surround right speaker Subwoofer When a subwoofer is connected to this unit and you want to get natural bass sound Select "SWFR" (subwoofer). The LFE signals as well as the low-frequency signals of other speakers set to "SML" (or "SMALL") are directed to the subwoofer. [. . . ] Please note that it is the customer's responsibility to ensure the product is adequately packaged when returning the product for repair. (3) Misuse, including but not limited to (a) failure to use the product for its normal purpose or in accordance with Yamaha's instructions on the proper use, maintenance and storage, and (b) installation or use of the product in a manner inconsistent with the technical or safety standards in force in the country where it is used. (4) Accidents, lightning, water, fire, improper ventilation, battery leakage or any cause beyond Yamaha's control. (5) Defects of the system into which this product is incorporated and/or incompatibility with third party products. [. . . ]