User manual YAMAHA RX-V520RDS

[. . . ] GB RX-V520RDS Natural Sound AV Receiver Ampli-tuner audio-vidéo OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 1 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install this unit in a well ventilated, cool, dry, clean place with at least 30 cm on the top, 20 cm on the right and left, and 10 cm at the back of this unit for ventilation space -- away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. Locate this unit away from other electrical appliances, motors, or transformers to avoid humming sounds. [. . . ] · A given input source is not output on the same REC OUT channel. (For example, the signal input from VCR 1 IN is not output on VCR 1 OUT. ) · Check the copyright laws in your country to record from records, CDs, radio, etc. Recording of copyrighted material may infringe copyright laws. 1, 4 VOLUME DIGITAL RDS MODE/FREQ D I G I TA L EON STANDBY /ON SURROUND PTY SEEK MODE START INPUT MODE PRESET /TUNING 6CH INPUT BASS TREBLE BALANCE SPEAKERS A B PROGRAM EFFECT PRESET/TUNING A/B/C/D/E FM/AM INPUT EDIT MEMORY TUNING MODE ­ + ­ + L R ON OFF MAN'L/AUTO FM AUTO/MAN'L MONO PHONES S VIDEO VIDEO L AUDIO R OPTICAL SILENT VIDEO AUX 2 4 2 If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture itself may be disturbed due to those signals. 1 Set the volume at the minimum level. VOLUME I Special considerations when recording DTS software The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in noise being recorded. Therefore, if you want to use this unit to record sources that have DTS signals recorded on them, the following considerations and adjustments need to be made. For DVDs and CDs encoded with DTS Only 2-channel analog audio signals may be recorded. Set the DVD player (or CD player) as described in the player's operation instructions so that the audio signals are output from the player's analog outputs. Front panel 2 Select the source you want to record. INPUT or Front panel Remote control 3 4 Begin recording by the recording component connected to this unit. Play the source and then turn up the volume to confirm the input source. VOLUME or Front panel Remote control 34 ADVANCED OPERATION SET MENU The SET MENU consists of 9 items including the speaker mode setting. Use the SET MENU to enjoy the optimum audio/video playback for your system. 1 2 Press AMP(TUNER) on the component selector. Press SET MENU to enter the SET MENU. INTRODUCTION y · You can adjust the items on the SET MENU while playing a source. 1 SPEAKER SET CENTER SP MAIN SP REAR LR SP BASS OUT MAIN LVL 3 Press PRG­ (or PRG+) repeatedly to select the item (1 to 9) you want to adjust. PREPARATION 2 3 4 5 HP TONE CTRL y I/O ASSIGN INPUT MODE DOLBY D. SET LFE LEVEL D-RANGE 6 7 8 9 DTS SET SP DLY TIME DISPLAY SET MEM. GUARD Depending on the item, press PRG­ (or PRG+) to select a sub item. · By pressing SET MENU repeatedly, you can select items in the same order as when pressing PRG­. 4 Press ­ or + once to enter the setup mode of the selected item. The last setting you adjusted appears on the display. BASIC OPERATION ADVANCED OPERATION Adjusting the Items on the SET MENU Adjustment should be made with the remote control. 5 1 3, 6 4, 5 2 Press ­ or + repeatedly to change the setting of the item. APPENDIX 6 Note · Some items require extra steps to change to the desired setting. Press PRG­ (or PRG+) repeatedly until the input source name appears to exit from the SET MENU. English 35 SET MENU Memory back-up The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the settings of the SET MENU you adjusted will return to the factory settings. If so, adjust the items again. I MAIN SP (main speaker mode) Choices: LARGE, SMALL Initial setting: LARGE LARGE Select this if you have large main speakers. The entire range of the left and right main channel signal is directed to the left and right main speakers. SMALL Select this if you have small main speakers. The lowfrequency signals (90 Hz and below) of the main channel are directed to the speakers selected with "BASS OUT". 1 SPEAKER SET (speaker mode settings) Use this feature to select suitable output modes for your speaker configuration. Note · When you select MAIN for "BASS OUT", the low-frequency signals (90 Hz and below) of the main channel are directed to the main speakers even if you select SMALL for the main speaker mode. Notes · When 96-kHz sampling digital signals are input to this unit, level adjustments in items "MAIN SP", "BASS OUT" and "MAIN LVL" are possible, but those in items "CENTER SP" and "REAR LR SP" are not affected. · When 6CH INPUT is selected as the input source, level adjustments in items of "1 SPEAKER SET" are not affected (except "MAIN LVL"). I REAR LR SP (rear speaker mode) Choices: LRG (large), SML (small), NON (none) Initial setting: LRG I CENTER SP (center speaker mode) By adding a center speaker to your speaker configuration, the unit can provide good dialog localization for many listeners and superior synchronization of sound and images. Choices: LRG (large), SML (small), NON (none) Initial setting: LRG LRG Select this if you have large left and right rear speakers or if a rear subwoofer is connected to the rear speakers. The entire range of the rear channel signal is directed to the left and right rear speakers. SML Select this if you have small left and right rear speakers. [. . . ] 37, 59 T TAPE/MD mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44 Test tone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Tuning Automatic tuning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 Manual tuning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]