User manual YAMAHA RX-V661

[. . . ] G RX-V661 AV Receiver Ampli-tuner audio-vidéo OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING GEBRUIKSAANWIJZING CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. Caution: Read this before operating your unit. 1 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2 Install this sound system in a well ventilated, cool, dry, clean place ­ away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. Allow ventilation space of at least 30 cm on the top, 20 cm on the left and right, and 20 cm on the back of this unit. [. . . ] "FM" or "AM" appears in the front panel display. Press 7 TUNING AUTO/MAN'L so that the AUTO indicator lights up in the front panel display. Lights up 1 2 3 Rotate the I INPUT selector on the front panel to select "TUNER" as the input source. Press 3 FM/AM to select the reception band. "FM" or "AM" appears in the front panel display. Press 7 TUNING AUTO/MAN'L so that the AUTO indicator disappears from the front panel display. AUTO A FM 89. 10MHz A FM 89. 10MHz No colon (:) No colon (:) If a colon (:) appears in the front panel display, tuning is not possible. Press 2 PRESET/TUNING to turn the colon (:) off. 4 Press 5 PRESET/TUNING l / h once to begin automatic tuning. When this unit is tuned into a station, the TUNED indicator lights up and the frequency of the received station is shown in the front panel display. · Press 5 h to tune into a higher frequency. · Press 5 l to tune into a lower frequency. If a colon (:) appears in the front panel display, tuning is not possible. Press 2 PRESET/TUNING to turn the colon (:) off. 4 Press 5 PRESET/TUNING l / h to tune into the desired station manually. y Hold down the button to continue searching. 50 En FM/AM tuning Automatic preset tuning You can use the automatic preset tuning feature to store up to 40 FM stations with strong signals (A1 to E8: 8 preset station numbers in each of the 5 preset station groups) in order. You can then recall any preset station easily by selecting the preset station number. Notes · Any stored station data existing under a preset station number is cleared when you store a new station under the same preset station number. · If the number of received stations does not reach 40 (E8), automatic preset tuning automatically stops after searching for all the available stations. · Only FM stations with sufficient signal strength are stored automatically by automatic preset tuning. If the station you want to store is weak in signal strength, tune into it manually and store it as described in "Manual preset tuning" below. · Only Radio Data System broadcasting station are stored automatically by automatic preset tuning (Europe model only). 1 2 Rotate the I INPUT selector on the front panel to select "TUNER" as the input source. Press 3 FM/AM to select "FM" as the reception band. "FM" appears in the front panel display. Press and hold 6 MEMORY for more than 3 seconds. The preset station number as well as the MEMORY and AUTO indicators flashes. After approximately 5 seconds, automatic presetting starts from the current frequency and proceeds toward higher frequencies. Flashes 3 Manual preset tuning You can also store up to 40 stations (A1 to E8: 8 preset station numbers in each of the 5 preset station groups) manually. BASIC OPERATION 1 2 Tune into a station. [. . . ] Speaker Impedance level If you use one set (A or B), the impedance of each speaker must be 8 or higher. Front If you use two sets (A and B), the impedance of each speaker must be 16 or higher. * Center Surround Surround back If you use one set (A or B), the impedance of each speaker must be 4 or higher. Front If you use two sets (A and B), the impedance of each speaker must be 8 or higher. Center Surround Surround back * 1 2 Set the operation mode selector to L AMP or L SOURCE. [. . . ]