User manual YAMAHA RX-V663

[. . . ] G RX-V663 AV Receiver Ampli-tuner audio-vidéo OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING GEBRUIKSAANWIJZING CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. Caution: Read this before operating your unit. 1 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2 Install this sound system in a well ventilated, cool, dry, clean place ­ away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. Allow ventilation space of at least 30 cm on the top, 20 cm on the left and right, and 20 cm on the back of this unit. [. . . ] Control range: ­6. 0 dB to +6. 0 dB Control step: 0. 5 dB A)EQUALIZER 1/2 A)EQUALIZER 2/2 [ ]/[ ]: Up/Down [ENTER]: Enter [ p TEST >OFF ON . CHANNEL;;;;FRONT L TEST >OFF ON CHANNEL;;;;FRONT L Equalizer A)EQUALIZER Use this feature to select the parametric equalizer or the graphic equalizer. Equalizer type select EQ TYPE SELECT Use this feature to select the type of equalizer. A)EQUALIZER EQ TYPE SELECT AUTO PEQ >GEQ [NATURAL] OFF 63Hz 160Hz 400Hz 1kHz [ ]/[ ]: Up/Down [p]/[[]: Select 0dB 0dB 0dB 0dB . 2. 5kHz 6. 3kHz 16kHz 0dB 0dB 0dB [ ]/[ ]: Up/Down [p]/[[]: Adjust [ [ y Press 9k / n to select a frequency band and 9l / h to adjust the selected frequency band. Note The "GEQ" parameter can be adjusted only when "GEQ" is selected in "EQ TYPE SELECT". [p]/[[]: Select [ENTER]: Enter Choice AUTO PEQ GEQ Functions Uses the parametric equalizer adjusted in "AUTO SETUP" (see page 33). Adjusts the built-in 7-frequency band graphic equalizer so that the tonal quality of the speakers matches. Press 9ENTER to display the graphic equalizer screen. Deactivates the equalizing feature. Test tone TEST Use this feature to make adjustments of "GEQ" while listening to a test tone. To select "TEST", press 9k / n repeatedly in the graphic equalizer screen. A)EQUALIZER 1/2 p p ADVANCED OPERATION . TEST >OFF ON CHANNEL;;;;FRONT L 0dB 0dB 0dB 0dB OFF 63Hz 160Hz 400Hz 1kHz [ ]/[ ]: Up/Down [p]/[[]: Select [ y Currently applied parametric equalizer type (see page 33) appears under "AUTO PEQ". Choice OFF Functions Does not output test tones and output the currently selected source component. Outputs test tones from the selected speakers. Note You can select "AUTO PEQ" only when you carry out "AUTO SETUP" in advance (see page 32). In this case, "AUTO PEQ" is automatically selected as the default setting. ON p English 81 En Customizing this unit (MANUAL SETUP) Low-frequency effect level B)LFE LEVEL Use this feature to adjust the output level of the LFE (lowfrequency effect) channel according to the capacity of your subwoofer or headphones. The LFE channel carries low-frequency special effects which are only added to certain scenes. This setting is effective when the input signal contains the LFE signal. Control range: ­20 to 0 dB Control step: 1 dB B)LFE LEVEL Dynamic range C)DYNAMIC RANGE Use this feature to select the amount of dynamic range compression to be applied to your speakers or headphones. This setting is effective only when this unit is decoding bitstream signals. C)DYNAMIC RANGE . HEADPHONE;;;;;;;MAX SPEAKER;;;;;;;;;MAX [ ]/[ ]: Up/Down [p]/[[]: Select [ . SPEAKER;;;;;;0dB HEADPHONE;;;;0dB [ ]/[ ]: Up/Down [p]/[[]: Adjust [ p Speakers SPEAKER Adjusts the dynamic range compression for the speakers. Headphones HEADPHONE Adjusts the dynamic range compression for the headphones. Choice Functions · MIN: Adjusts the dynamic range to narrow when this unit is decoding bitstream signals (except Dolby TrueHD). · AUTO: Adjusts the dynamic range according to the instruction of the input source signals when this unit is decoding Dolby TrueHD signals. When this unit is decoding Dolby TrueHD signals, the dynamic range control is always active regardless of the instruction of the input source signals. [. . . ] (4) Accidents, lightning, water, fire, improper ventilation, battery leakage or any cause beyond Yamaha's control. (5) Defects of the system into which this product is incorporated and/or incompatibility with third party products. (6) Use of a product imported into the EEA and/or Switzerland, not by Yamaha, where that product does not conform to the technical or safety standards of the country of use and/or to the standard specification of a product sold by Yamaha in the EEA and/or Switzerland. (7) Non AV (Audio Visual) related products. [. . . ]