User manual YAMAHA RX-17E

[. . . ] È. ) 2 The engine number is stamped in the location as shown. Ê. ) Also, record and keep the ID numbers in a separate place in case the snowmobile is stolen. ESU00011 2- INTRODUCTION Congratulations on your purchase of a Yamaha snowmobile. This model is the result of Yamaha's vast experience in the production of fine sporting and touring snowmobiles. It represents the high degree of craftsmanship and reliability that have made Yamaha a leader in these fields. [. . . ] G Do not use the strap as a mounting point for cargo or accessories. @ 7-8 ESU00347 Driving WARNING @ Be sure to read the "SAFETY INFORMATION" and "Riding your snowmobile" sections carefully before operating the snowmobile. @ NOTE: @ Make sure that the engine is warmed up enough before riding. @ For RX10/RX10S/RX10M/RX10MS 1. Release the parking brake by moving the parking brake lever to the right. Press the throttle lever slowly to move the snowmobile. Turn the handlebar in the desired direction. Squeeze the brake lever to stop the snowmobile. Apply the parking brake by moving the parking brake lever to the left. To select the desired operating position, pull the shift lever out, slide it to "FWD" or to "REV" until it stops, and then release it. 1 2 3 4 Pull out Slide to "FWD" (Forward) Slide to "REV" (Reverse) Release WARNING @ G G G G @ Make sure that the throttle lever is fully released and the snowmobile is at a full stop before shifting. Be sure to slide the shift lever to "FWD" or "REV" until it stops completely and only while the engine is idling. Make sure that the area behind the snowmobile is clear before reversing. Reduce speed and avoid sharp turning when operating the snowmobile in reverse. 7-9 CAUTION: @ Do not shift from "FWD" to "REV" or from "REV" to "FWD" while the snowmobile is moving. Tighten or replace gasket if necessary. Carburetor Engine stop switch Throttle override system (T. O. R. S. ) Throttle lever Exhaust system 5-10 5-3, 6-5 5-2, 6-5 It is recommended that these items be serviced by a Yamaha dealer. 8-1 Item Remarks Preoperation check (Daily) Initial 1 month or 800 km (500 mi) (40 hr) Every Seasonally or 3, 200 km (2, 000 mi) (160 hr) Page Drive guard V-belt Drive track and idler wheels Slide runners Check for cracks, bends or damage. Check deflection, and for wear and damage. Adjust free play and/or replace pads if necessary. Lubricate shaft with specified grease as required. Replace bulbs if necessary. G G G G G G G See NOTE on page 8-3. Every 1, 600 km (1, 000 mi) G G Initial at 500 km (300 mi) and every 800 km (500 mi) thereafter. G G G G G G 5-12, 6-7 6-7, 8-15­8-17 6-8, 8-28­8-30 6-8 5-10­5-11, 6-6­6-7 8-19­8-20 Brake and parking brake 8-20 Disc brake installation Drive chain oil Drive chain Skis and ski runners Steering system Strap (RX10M/RX10MS) 8-17­8-18 8-18 6-9 6-9 Lights 6-9, 8-33 It is recommended that these items be serviced by a Yamaha dealer. 8-2 Item Remarks Preoperation check (Daily) Initial 1 month or 800 km (500 mi) (40 hr) Every Seasonally or 3, 200 km (2, 000 mi) (160 hr) G Page Check engagement and shift speed. Primary and second- Inspect weights/rollers and bushings for wear-for primary. ary clutches Inspect ramp shoes/bushings for wear-for secondary. Steering column bearing Ski and front suspension Suspension component Parking brake cable end and lever end/ throttle cable end Shroud latches Fittings and fasteners Tool kit and recommended equipment Lubricate with specified grease. Make sure that the shroud latches are hooked. [. . . ] Moisture and acids form during combustion which can actually increase the chance for corrosion damage during the storage period. @ 5. Protection Apply a coat of wax to painted surfaces. Apply suitable protectants to the exterior of the engine, drive track, and to other metal, plastic, and rubber parts. Battery Remove the battery from the snowmobile. [. . . ]