User manual YAMAHA RX-21LE

[. . . ] To prevent fire or electrical shock, do not place this unit where it may get exposed to rain, water, and/or any type of liquid. Do not expose this unit to sudden temperature changes from cold to hot, and do not locate this unit in a environment with high humidity (i. e. a room with a humidifier) to prevent condensation inside this unit, which may cause an electrical shock, fire, damage to this unit, and/or personal injury. On the top of this unit, do not place: ­ Other components, as they may cause damage and/or discoloration on the surface of this unit. [. . . ] SP DELAY TIME CENTER; 0ms to 5ms REAR CNTR; 0ms to 30ms BLUE BACK; AUTO/OFF OSD SHIFT; 0 to 10 DIMMER; ­4 to 0 OFF / ON 45 14. DISPLAY SET Selects the display settings. 45 15. MEMORY GUARD Locks DSP program parameters and other SET MENU settings. 45 37 SET MENU Items Operating the SET MENU Introduction Adjustment should be performed with the remote control. Some items require extra steps to change to the desired setting. PARAMETER / SET MENU Cursor buttons Preparations 1 Set PARAMETER/SET MENU to SET MENU. 2 Press h or g repeatedly to select an item from the table of SET MENU, then press + or ­ to enter the setting of that item. Basic Operation · The last item you adjusted appears on the display. · Some items have sub items. OSD (On Screen Display) SET MENU 1/4 1 2 3 4 SPEAKER SET LOW FREQ. TEST L/R BALANCE HP TONE CTRL Front Panel Display 2 LOW FREQ. TEST -/+ : Enter 3 Press + or ­ to change the setting of the item. Advanced Operation 2 LOW FREQ. TEST TEST TONE. . . . . . . . . OFF OUTPUT. . . MAIN L/R FREQ. . . . . . . . . . . . . . . . . . . 88Hz 2 LOW FREQ. TEST TEST TONE. . . . . . . . . OFF 4 Press h or g repeatedly or a DSP program button to exit the SET MENU. Additional Information or Appendix 38 SET MENU Items 1. MAIN LEVEL) English Use this feature to select suitable output modes for your speaker configuration. You must set the output mode when you use a subwoofer. s 1A. CENTER SP (Center Speaker Mode) By adding a Center speaker to your speaker configuration, this unit can provide good dialogue localization for many listeners and superior synchronization of sound and images. The OSD shows a large, small, or no center speaker depending on how you set this item. Select the "LRG" (Large) setting if you have a large Center speaker. The entire range of Center channel signals is sent to the Center speaker. Select the "LRG" setting if you have a large Rear Center speaker. The entire range of Rear Center channel signals is sent to the Rear Center speakers. Select the "SML" (small) setting if you have a small Rear Center speaker. Rear Center channel low frequency signals of 90 Hz and below are distributed to speakers selected with the 1E. Select the "NONE" setting if you do not have a Rear Center speaker. The Rear Center signal is directed to the Rear L/R speakers. Large Small None 1D REAR CT SP Preparations 1D REAR CT SP 1D REAR CT SP 1D REAR CT SP "LRG SML NONE "LRG SML NONE LRG "SML NONE LRG SML "NONE s 1E. LFE/BASS OUT (Bass Output Mode) LFE signals carry low frequency effects when this unit decodes DTS or Dolby Digital signals. Low frequency signals are defined as 90 Hz and below. The initial setting is "BOTH". Select the "SWFR" (Subwoofer) setting if you use a Subwoofer. The LFE signals are directed to the Subwoofer. Basic Operation Select the "MAIN" setting if you do not use a Subwoofer. [. . . ] 480 W Standby Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 2 W AC Outlets (Total 100W maximum) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 (Switched) Dimension (W x H x D) . . . . . . . . . . . . . . . . . . . . . . 449 x 191 x 468 mm (17-5/8" x 7-1/2" x 18-7/16") Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]