User manual YAMAHA S3115H

[. . . ] Cable/s supplied with this product MUST be used. Failure to follow instructions could void your FCC authorization to use this product in the USA. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. [. . . ] 7 TREBLE knob Used to adjust the treble sound of the built-in speakers. 8 Foot Controller connector Connect the optional Yamaha FC-4, FC-5 or FC-7 foot controller here. 9 Amplified speakers Amplified speakers are mounted to the underside of the piano. 7 Remote Control 6 [SONG SELECT] buttons Used to select songs. 1 RECORD PART SELECT L R SEARCH 0 q w 7 [PLAY] button Used to start playback. 8 [PAUSE] button Used to pause playback and recording. 9 [STOP] button Used to stop playback and recording. 0 [PART SELECT] buttons For L/R and Ensemble songs, these buttons are used to choose which part will play: left-hand part, right-hand part, or both parts. They are also used to select a part for recording. q [SEARCH] button Used to access the Search function. Toggles the floppy disk and Memory Disks (0 ~ 9 and A ~ F). e [TRANSPOSE] buttons Used to transpose song playback. [­] transposes down, [+] transposes up, and [0] resets the transposition value to 00. · Wipe the CD with a clean cloth before playback. · Remove the CD before you turn off the Disklavier. The disk will pop out. Remove the disk and return it to its case. Note: Do not eject a disk during playback, recording, or when the message "WRITING TO DISK" is shown on the display and the REC indicator is flashing. Doing so can seriously damage the disk drive and the floppy disk. 10 Inserting & Removing CDs Press the CD eject button so that the CD tray pops out about 1 cm. Then, carefully pull it out as far as it will go. To insert a CD, place the CD on the tray and gently press down on it so that the center of the CD is clamped in place. To remove the CD, slowly lift the CD. Note: The CD eject button can be used only when the Control Unit is turned on. Memory Disks Besides floppy disks and CDs, the Disklavier has 64 megabytes (4 megabytes × 16 Memory Disks) of internal flash memory for storing song data. They are numbered from 0 to 9 and A to F. They can be used in the same way that you use floppy disks to store songs. Memory Disks are ideal for storing many songs, especially when you want to program your Disklavier to automatically play back many songs with the Chain Play or Timer Play features. (See Chapter 2 "Chain Play -- Playing Back Memory Disks in a Group" and Chapter 3 "Timer Play" in the Advanced Operation Manual for details. ) See also Chapter 1 "Storing & Managing Songs on Disks" in the Advanced Operation Manual for more information on using Memory Disks. English Chapter 3: Disks Used with the Disklavier SELECT DRIVE ROL UNIT CONT DKC60RCD REC E PLAY/PAUS STOP SONG EV · FWD SELECT/R ENTER FUNC. [. . . ] See "Formatting Disks" on page 17 in the Advanced Operation Manual. 7 When you finish playing your song, press [STOP]. When [STOP] is pressed, the following display appears. 2b Use the [SELECT] buttons to select the number of the memory disk that will serve as the recording destination. English 3 Press [REC] to engage the Record Standby mode. The REC indicator lights and the PLAY/PAUSE indicator flashes. A new song number is created for the new recording. For example, if the last song to be recorded was No. 6, then the new song will be No. 7. The following table gives a description of each of options. Option SAVE NEW Description The new recording is saved under the current song number. [. . . ]