User manual YAMAHA S90E1

[. . . ] MUSIC SYNTHESIZER Appendix Reference Quick Guide Basics Section SPECIAL MESSAGE SECTION PRODUCT SAFETY MARKINGS: Yamaha electronic products may have either labels similar to the graphics shown below or molded/stamped facsimiles of these graphics on the enclosure. The explanation of these graphics appears on this page. Please observe all cautions indicated on this page and those indicated in the safety instruction section. ENVIRONMENTAL ISSUES: Yamaha strives to produce products that are both user safe and environmentally friendly. We sincerely believe that our products and the production methods used to produce them, meet these goals. [. . . ] Determines how the Arpeggio plays back when playing the keyboard. 45 45 45 45 *28 71 72 73 CenterKey EGTimeSens CenterKey *28 *12 *28 *28 *12 *29 *29 *34 74 75 76 77 78 Bank Type Tempo Switch (ArpSwitch) Hold *30 45 *31 *32 *33 *34 *35 *36 *12 79 KeyMode Arpeggio Key Mode 80 81 82 83 84 85 86 87 VelMode NoteLimit VelocityLimit UnitMultiply VelocityRate GateTimeRate OutputSwitch TransmitCh Arpeggio Velocity Mode Arpeggio Note Limit Low/ High Arpeggio Velocity Limit Low/High Arpeggio Unit Multiply Arpeggio Velocity Rate Arpeggio Gate Time Rate Arpeggio MIDI Out Switch Arpeggio MIDI Transmit Channel BC/Assign1/Assign2/FC1/ FC2 Control Number Transmit Switch Determines the playback velocity of the Arpeggio, or how it responds to your own playing strength. Determines the lowest and highest notes in the Arpeggio's note range. Determines the lowest and highest velocity in the Arpeggio's velocity range. This lets you control when the Arpeggio sounds by your playing strength. For example, if you set a value of 200%, the playback time will be doubled and the tempo halved. If you set a value of 50%, the playback time will be halved and the tempo doubled. Determines how much the Velocity of the Arpeggio playback is offset from the original value. For example, a setting of 100% means the original values are used. Determines how much the Gate Time (length) of the Arpeggio notes is offset from the original value. A setting of 100% means the original values are used. When set to on, Arpeggio playback data is output from the MIDI terminal. Determines the MIDI transmit channel for Arpeggio playback data. KbdCh. . . Arpeggio playback data is transmitted by KBDTransCh ([F5][SF1] Keyboard Transmit Channel) in the Utility mode (Performance/Mixing) Sets the control number for the Breath Controller (BC), Assign 1/2 sliders (AS1/2), and Foot Controllers 1/2 (FC1/2). 53 47 *13 *37 *38 *37 *39 88 BC/AS1/AS2/ FC1/FC2 (Transmit Switch) *40 89 When the relevant parameter is set to "on, " playing the selected zone will transmit the corresponding MIDI data, such as Control Change and Program Change messages. Pressing the [F5] button switches between display of all four Zones and one single Zone (in which all transmit channel settings are shown). In the four-Zone display, use the cursor buttons to scroll. The parameters differ depending on the selected type. 63 *41 101 90 Type Filter Type Appendix Reference Quick Guide Basics Section Ref. # 91 92 93 94 95 96 97 Gain Display Parameter Name Filter Gain Filter Cutoff Frequency Filter Resonance Filter Width Distance HPF Cutoff Frequency HPF Cutoff Frequency Key Follow FEG Time Velocity Sensitivity FEG Time Segment FEG Level Velocity Sensitivity Filter Cutoff Velocity Sensitivity Filter Resonance Velocity Sensitivity FEG Time FEG Level FEG Depth Filter Cutoff Key Follow Sensitivity Filter Cutoff Key Follow Center Key FEG Time Key Follow Sensitivity FEG Time Key Follow Center Key Filter Cutoff Scaling Break Point Filter Cutoff Scaling Offset Low Pass Filter Cutoff Determines the cutoff frequency for the low pass filter. Explanation Determines the Gain (the amount of boost applied to the signal sent to the Filter). Determines the cutoff frequency for the Filter, or the central frequency around which the Filter is applied. Determines the amount of Resonance (harmonic emphasis) applied to the signal at the cutoff frequency. With the BPFw, this parameter is used to adjust the width of the band of signal frequencies passed by the filter. Determines the distance between the Cutoff frequencies, for the Dual Filter types. (The two filters in combination are connected in parallel fashion. ) Determines the central frequency for the Key Follow parameter (below) of the HPF. [. . . ] Zweigniederlassung Wien Schleiergasse 20, A-1100 Wien, Austria Tel: 01-60203900 MIDDLE EAST TURKEY/CYPRUS Yamaha Europa GmbH. Siemensstraße 22-34, 25462 Rellingen, Germany Tel: 04101-3030 NEW ZEALAND Music Houses of N. Z. Ltd. 146/148 Captain Springs Road, Te Papapa, Auckland, New Zealand Tel: 9-634-0099 THE NETHERLANDS Yamaha Music Nederland Clarissenhof 5-b, 4133 AB Vianen, The Netherlands Tel: 0347-358 040 OTHER COUNTRIES Yamaha Music Gulf FZE LB21-128 Jebel Ali Freezone P. O. Box 17328, Dubai, U. A. E. Tel: 971-4-881-5868 COUNTRIES AND TRUST TERRITORIES IN PACIFIC OCEAN Yamaha Corporation, Asia-Pacific Music Marketing Group Nakazawa-cho 10-1, Hamamatsu, Japan 430-8650 Tel: 053-460-2312 BELGIUM Yamaha Music Belgium Rue de Geneve (Genevastraat) 10, 1140 - Brussels, Belgium Tel: 02-726 6032 HEAD OFFICE Yamaha Corporation, Pro Audio & Digital Musical Instrument Division Nakazawa-cho 10-1, Hamamatsu, Japan 430-8650 Tel: 053-460-2445 SY24 FCC INFORMATION (U. S. A. ) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! [. . . ]