User manual YAMAHA SLG100N/SLG120NW

[. . . ] SLG-100N/120NW Owner's Manual English 1 Thank you for purchasing the Yamaha Silent Guitar. In order to obtain the maximum performance and enjoyment from your Silent Guitar, we urge you to read this Owner's Manual thoroughly before using the instrument. Please keep this Owner's Manual in a safe place for later reference. Contents Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Main Body/Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · Avoid plugging the AC power adaptor into the same AC outlet as appliances with high power consumption, such as electric heaters or ovens. Also avoid using multi-plug adaptors since these can result in reduced sound quality and possible damage. I Turn Power OFF When Making Connections · To avoid damage to the Silent Guitar and other devices to which it is connected (a sound system, for example), turn the power switches of all related devices OFF prior to connecting or disconnecting audio cables. I Handling and Transport · · · · Never apply excessive force to the controls, connectors or other parts. Always unplug cables by gripping the plug firmly, not by pulling on the cable. Disconnect all cables before moving the unit. Physical shocks caused by dropping, bumping, or placing heavy objects on the unit can result in scratches and more serious damage. I Cleaning · Clean the guitar body with a dry soft cloth. · A slightly damp cloth may be used to remove stubborn grime and dirt. · Never use cleaners such as alcohol or thinner. I Electrical Interference · This unit contains electric circuitry and may cause interference if placed too close to radio or television receivers. If this occurs, move it further away from the affected equipment. YAMAHA is not responsible for damage caused by improper handling or operation. 3 Main Body/Accessories After opening the packaging, please check that all the parts listed below are included. · Main body · Left frame · Stereo earphones · AC adaptor : PA-D09 · Soft case * SLG-120NW only 4 Nomenclature G Front Tuning peg G Rear Nut Neck Fingerboard Frame attachment screw 1 (Doubles as the strap pin) Left frame (Removable) Right frame (Fixed) Horn (Leg support) Body Finger rest (SLG-120NW only) Saddle Pickup (underneath the saddle) Bridge Controls See page 6. OPEN THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. · THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003. · CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB-003 DU CANADA. SILENT GUITAR MODEL SLG-100N AC POWER ADAPTOR : YAMAHA PA-1E OR PA-3C OR PA-D09 BATTERY : 9V 6LR61 OR 6F22 MADE IN INDONESIA N89 AUX VOL MIN MAX LINE OUT AUX IN Frame attachment screw 2 (Doubles as the strap pin) 5 Nomenclature G Controls Battery compartment use 6LR61 9V alkaline battery OPEN POWER lamp REVERB switch OFF 1 2 REVERB VOLUME VOLUME control DC-IN jack (Power adaptor connector) DC-IN 9~12V THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. · THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003. To remove the frame, simply reverse the order of the procedure described above, removing the upper rod from tha main body before removing the lower rod. · After the frame is attached, make sure attachment screws 1 and 2 are tightened firmly. Using the instrument with the screws loose will result in rattle or other noise during performance. · When transporting the instrument, please carry the instrument by its neck or main body. Holding the instrument by only its left or right frame will result in damage of the frame or the frame's fixed parts. I About the Strap Pin The frame attachment screw can be used as a strap pin for a separately purchased guitar strap. · Make sure that the strap is firmly hooked onto the strap pin so the instrument does not drop during performance. 7 Tuning Use a tuning meter, pitch pipe, tuning fork, piano, etc. , and tune the open strings to the pitches shown below. · If the string's pitch is high, loosen the string until the string's pitch is slightly lower than the tuning pitch, then tune while raising the string's pitch. Open 1st String's Pitch: E Open 2nd String's Pitch: B Open 3rd String's Pitch: G Open 4th String's Pitch: D Open 5th String's Pitch: A Open 6th String's Pitch: E 1. 3. Play the standard pitch "lah" (A3: 440Hz) on a tuning fork, etc. , and tune the open 5th string to the same pitch. Play the pitch produced by pressing the 5th string at the 5th fret, and tune the open 4th string to the same pitch. Play the pitch produced by pressing the 4th string at the 5th fret, and tune the open 3rd string to the same pitch. Play the pitch produced by pressing the 3rd string at the 4th fret, and tune the open 2nd string to the 5. Play the pitch produced by pressing the 2nd string at the 5th fret, and tune the open 1st string to the same pitch. [. . . ] Doing so can lead to irreparable damage to your hearing. · Do not disconnect or connect the plug when the headphones are placed over your ears. 11 Connecting External Devices Silent Guitar · Using the cord hook Wrap the power adaptor's cord around the cord hook (prevents cord from being unplugged). SILENT GUITAR MODEL SLG-100N AC POWER ADAPTOR : YAMAHA PA-1E OR PA-3C OR PA-D09 BATTERY : 9V 6LR61 OR 6F22 MADE IN INDONESIA Stereo earphones N89 AUX VOL MIN MAX LINE OUT AUX IN Cord hook MD recorder, Mixer, etc. (Stereo output) Power adaptor Electric outlet 6LR61 Alkaline battery or OPEN DC-IN THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. [. . . ]