User manual YAMAHA SPS-80

[. . . ] English SPEAKER STAND Read this before setup SPS-80 PRECAUTIONS SETUP INSTRUCTIONS Thank you for selecting this YAMAHA SPS-80 speaker stand. Français This speaker stand is only for the speaker systems listed in "USABLE SPEAKERS" below. Do not use the speakers other than these listed. To prevent the speaker from falling, use the screws and parts provided with the stand. [. . . ] x Length: 4 x 8 mm) Hexagon socket set screws (Diam. x Length: 4 x 6 mm) Wrench (hexagonal) Cable protection seal Rubber cap 4 SETUP PROCEDURES (You will need a screwdriver for the setup. ) Attach the speaker mounting bracket to the speaker by screwing it into the screw hole on the bottom of the speaker. 1 Attach the support to the base by fastening the three + face screws from the holes on the bottom of the base. Base Speaker (not included) Name plate Support 5 * Do not overtighten the + self-machine screws. Doing so may damage the screws or assembly. 2 Pass the speaker cable through the pole from the end without the cut. Then pass the cable through the hole on the speaker mounting bracket from the side with the groove as shown in the figure. Pass the speaker cable through the support from the bottom. * A speaker cable more than 4 mm x 2 mm in diameter cannot be used. If you use such a cable, connect it to the speaker's terminals without passing it through the pole. Speaker cable (not included) Support Speaker cable Cut Pole Front Back Speaker mounting bracket Groove E-2 6 Pull out the speaker cable in the length of 15 to 16 cm from the speaker mounting bracket. Then attach the speaker mounting bracket to the pole so that the speaker cable fits to the cut in the pole. 15­16 cm 8 English Adjust the speaker direction. Then put the wrench into the hole of the speaker monting braket, and tighten the bracket to the speaker by moving the wrench counterclockwise. Cut 9 Screw Connect the speaker cable to the speaker's terminals correctly. * Refer to the instruction manual of the speakers for connecting the speaker cables. 7 Insert the pole to the support, and adjust the height of the stand. After adjusting the height, fasten the hexagon socket set screws into the two holes on the support using the longer handle of the included wrench, and attach the rubber cap to the support. * The line on the pole shows the limit of the stand height. Do not let the line of the stand height limit go beyond the upper end of the support. Otherwise, the hexagon socket set screw of the lower side becomes ineffective and the fixation becomes unstable. 10 Align the speaker cable to the grooved part of the bottom of the base, and fix the cable on the base by putting the protection seal on it. [. . . ] YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND SCANDINAVIA A. B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VASTRA FRÖLUNDA, SWEDEN MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST. , SOUTH MELBOURNE, 3205 VIC. , AUSTRALIA Printed in China V975830 [. . . ]