User manual YAMAHA SREV1

[. . . ] SAMPLING REVERBERATOR Owner's Manual POWER INPUT 1 2 3 4 CLIP CH SIGNAL 1 OUTPUT 2 3 4 FS LOCK 48K 44. 1K ON OFF MEMORY CARD CD-ROM Keep This Manual For Future Reference. E FCC INFORMATION (U. S. A. ) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. [. . . ] Use the cursor buttons to select the SAVE button, and then press [ENTER]. See "Using the Title Edit dialog Box" on page 41 for more information. Use the cursor buttons to select the OK button, and then press [ENTER]. (To cancel the operation, select the CANCEL button and then press [ENTER]. ) If a program with the same title already exists, a confirmation dialog box appears. Select YES to overwrite the existing program, or select NO to cancel the operation. Note that if the existing program is write-protected, it cannot be overwritten. The current program, and its impulse-response data, is saved to the selected drive, and the Edit status indicator disappears (see page 18). 3 4 5 Editing Program Titles in the Library The titles of programs stored on the following drives can be edited: Internal Card or PC Card. 1 2 Use the [PROGRAM] button to locate the Library page. Use the cursor buttons to select a drive button, and then press [ENTER] to make it the active drive. The programs stored on the active drive appear in the program list. Use the DATA wheel or the [­1/DEC] and [+1/INC] buttons to select a program. The titles of write-protected programs cannot be edited. Use the cursor buttons to select the TITLE EDIT button, and then press [ENTER]. See "Using the Title Edit dialog Box" on page 41 for more information. Use the cursor buttons to select the OK button, and then press [ENTER]. (To cancel the operation, select the CANCEL button and then press [ENTER]. ) The new title is saved. 3 4 5 6 SREV1--Owner's Manual Working with the Library 47 Protecting Library Programs Programs stored on the following drives can be write-protected to prevent accidental deletion: Internal Card or PC Card. 1 2 Use the [PROGRAM] button to locate the Library page. Use the cursor buttons to select a drive button, and then press [ENTER] to make it the active drive. The programs stored on the active drive appear in the program list. Use the DATA wheel or the [­1/DEC] and [+1/INC] buttons to select a program. Use the cursor buttons to select the PROTECT button, and then press [ENTER]. The Protect icon ( ) appears to the right of the program's title. 3 4 5 Press the [ENTER] button again to unprotect the program. The Protect icon disappears. Deleting Library Programs Programs stored on the following drives can be deleted: Internal Card or PC Card. The preset programs loaded into the Internal Card at the factory are also available on the supplied CD-ROM. 1 2 Use the [PROGRAM] button to locate the Library page. [. . . ] PEQ--Abbreviation for "parametric EQ. " Program--Measured impulse response data is combined with variable parameters such as reverb time and initial delay to form reverb programs. User programs can be stored in the Quick memories, Internal Card or PC Card. Program Change--A type of MIDI message for recalling programs. Project--A Project contains all the Quick memory programs and the current program settings. [. . . ]